Maintenance; Specifications - Dell DCH072 Instruction Manual

ENglIsh
Drilling in Masonry
When drilling in masonry, use carbide‑tipped bits rated for
percussion drilling and be certain that the bits are sharp. Use
a constant and firm force on the tool to drill most effectively.
A smooth, even flow of dust indicates the proper drilling rate.
Hammerdrill Operation (Fig. I)
1. Turn the mode selector 5
symbol 15 .
2. When drilling, use just enough force on the hammer
to keep it from bouncing excessively or "rising" off the
bit. Too much force will cause slower drilling speeds,
overheating, and a lower drilling rate.
3. Drill straight, keeping the bit at a right angle to the work.
Do not exert side pressure on the bit when drilling as
this will cause clogging of the bit flutes and a slower
drilling speed.
4. When drilling deep holes, if the hammer speed starts to
drop off, pull the bit partially out of the hole with the tool
still running to help clear debris from the hole.
5. For masonry, use carbide‑tipped bits or masonry
bits. A smooth even flow of dust indicates the proper
drilling rate.

MAINTENANCE


WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start‑up can cause injury.
Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the
risk of eye injury, always wear approved eye protection
when performing this procedure.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non‑metallic parts of the
tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
30
to the rotary hammer
WALT recommended
e
Maximum Recommended Capacities
RPM 0–910
BPM 4280
Bits, Masonry Drilling 5/32"–3/8" (optimum drilling range)
Dust Extraction System (Fig. K)
The use of a dust extraction system is recommended to
reduce potentially harmful airborne dust and to prolong tool
and accessory life.
Consult your dealer for further information on suitable dust
extraction systems.
Repairs
The charger and battery pack are not serviceable.

WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by a
D WALT factory service center or a D
e
service center. Always use identical replacement parts

SPECIFICATIONS

DCH072
WALT authorized
e
12V Max*