Sharp EM-PH1A User Manual page 6

4
Inserting your Phone into the Phone
Holder
Before inserting your phone make sure that the clamps are open.
1. To set the phone holder ready for your phone to be clamped, push the
clamp release levers towards the centre of the device as shown in the
picture. Note that there will be resistance when pushing the clamp
release levers.
2. The clamps will move to their furthest position when the clamp release
levers are pushed all the way in.
3. Place your phone in the holder as shown. The clamps on the left and
right must be in the fully extended position. Make sure that the phone
is resting on the bottom pads as shown.
4. Push your phone in a downwards direction. The bottom pads will move
downwards and the clamp will snap into place. At the same time the
clamp release levers will move outwards. Check that your phone is held
tightly and does not move within the clamp.
To release your phone, push in the clamp release levers. Ensure that you
are also holding your phone to ensure that it does not fall.