Connecting WAN, LAN, and Voice Cables
Figure 3-53 Typical Cable Arrangement
1
1
Connecting WAN, LAN, and Voice Cables (With Chassis Shield—Telco Only)
To connect the cables, install the chassis shield, and organize the cables into bundles, perform this
procedure:
Note
The Cisco 3660 router telco chassis is identified by its part number, CISCO3662-xC-CO.
Step 1
Connect each WAN, LAN, and voice cable to the appropriate connector on a network module or interface
card.
Note
Note
Cisco 3600 Series Routers Hardware Installation Guide
3-40
VOICE
2V
V1
VIC
FXS
SERIAL
4T
SERIA L 3
SERIA L 2
SERIA L 1
CN/LP RXC
RXD
TXC
TXD
CN/LP RXC
RXD
TXC
TXD
CN/LP RXC
RXD
LAN, WAN, and voice cables
Do not organize the cables into bundles until after you install the chassis shield. Leave a
generous length of cable to allow for installation of the cable shield.
You can route cables through the cutout at the left of the chassis, through the openings in the
chassis shield, or through both areas. In each routing, all WAN, LAN, and voice cables must exit
toward the left. (See
Figure 3-55
HIGH SPEED SERIAL
1HSSI
V0
1
SEE MANUAL BEFORE INSTALLAT
0
ION
EN
ETHERNET
4E
SERIA L 0
ETH 3
ETH 2
ETH 1
3
2
1
0
LINK
EN
ACT
TXC
TXD
CN/LP RXC
RXD
TXC
TXD
2
Power wires
and
Figure
3-56.)
Chapter 3
Installing the Router
2
H
ETH 0
OL-2056-05