Meta System BLE42 User And Installation Manual page 10

To make the starter immobilization it's available an internal relay into the module BLE42 and its C - NC contacts are loca-
ted on the module panel to be connected with a couple of 6,3 mm Faston (Fig. 7/8). The activation logic for the internal
relay give a contacts status change every time the instrument panel is turned on when the BLE42 Module is armed.
CUT ORIGINAL WIRE
PETROL
C
PUMP
ELECTRONIC
INJECTION
Fig.7
10.1 EMERGENCY DISARMING BY OVERRIDE CODE
If the ID-TAG Card B9.5 was lost or in case of flat battery it is possible disarm the BLE42 module introducing the Override
PIN CODE. By the PRG007 programmer it is possible select if use a complete PIN CODE (5 digits) or short PIN CODE
(3 digits), in the following paragraph is described how to introduce the override code and if short PIN CODE has been
selected (factory set-up) the disarm will be after introduced the third digit. Note: when the BLE42 module has been disar-
med by the Override code the system stay disarmed until the voluntary reactivation.
With ignition
key OFF
press hold
the LED/Button
for 10 sec
until the LED
will be ON,
releases
the button
and start with
the PIN CODE
digits
inserting.
10.2 REACTIVATION OF THE IMMOBILISER PROTECTION
To reactivate the system follow the steps below:
• With ignition key OFF press hold the LED/Button for 3 sec until the LED will be ON, releases the button
• After released button the LED flash quickly, press again the button within 3 sec to confirm the reactivation.
• The LED will flash slowly to indicate the immobilizer protection reactivation.
Using the programming tool PRG007 it's possible perform some set-up of the BLE42 module, below the list of the main
set-up options:
• Possibility to Set-Up the 3 programmable outputs.
• Possibility to adjust the BLE42 module radio sensitivity range to set the receiving distance between module and its ID-TAG
Card B9.5.
• Customization of the Override code and selecting from use 5 digit or 3 digits code.
• Pairing the new bluetooth CARDs (max 5 cards) or removing the lost or not working CARDs.
• Changing the CARD Behavior from standard mode ID-TAG (automatic recognizing) as a remote control
(the CARD emit only one time pressing the button).
9.
INTERNAL RELAY IMMOBILIZER
NC
BLE42
11. SET-UP OF THE BLE42 MODULE
CUT ORIGINAL WIRE
STARTER
MOTOR
Fig.8
10
INSTALL AN
ADDITIONAL
30A RELAY
C
BLE42
NC