DeWalt DCW600B Instruction Manual page 14

English
Fig. L
5
Adjusting the Depth of Cut (Fig. L)
1. Open the locking lever
5
adjustment ring until the bit just touches the work
piece. Turning the ring clockwise raises the cutting
head while turning it counterclockwise lowers the
cutting head.
2. Turn the micro-adjustment scale
0 on the scale lines up with the pointer on the bottom
of the depth adjustment ring.
3. Turn the depth adjustment ring until the pointer lines
up with desired depth of cut marking on the micro-
11
adjustment scale
nOTE: Each mark on the adjustment scale represents
a depth change of 1/64" or .015" (0.4 mm) and one
full (360º) turn of the ring changes the depth 0.5"
(12.7 mm).
4. Close the locking lever
Removing the Motor from the Fixed
Base (Fig. K)
1. Remove the battery pack from the motor. Refer to
Installing and Removing the Battery Pack.
2. Open the locking lever
3. Grasp the motor unit with one hand, depressing both
21
quick release tabs
4. With the other hand, grasp the base and pull motor
from the base.
Set-up: Plunge Base (Fig. A, M)
Inserting the Motor into the Plunge
Base
1. Remove the depth adjustment ring
6
motor . It is not used with the plunge base.
nOTE: Snap depth adjustment ring onto fixed base,
when not in use, to prevent loss.
12
12
and turn the depth
11
clockwise until the
.
12
to lock the base.
12
on the base.
.
5
from the
2. Open the plunge base locking lever
3. Making sure the spindle lock button is facing front,
insert the motor
12
on the motor with the guide pins
the motor down until the motor stops on the motor
19
stop .
4. Close the locking lever
Fig. M
11
Adjusting the Plunge Routing Depth
(Fig. M)

WARNING: Laceration hazard. Do not change the
turret stop while the router is running. This will
place your hands too near the cutter head.

WARNING: To prevent loss of control, ALWAYS
tighten the travel-limiting nuts together.
Inadvertent movement could prevent full
bit retraction.

WARNING: To prevent loss of control, set
the travel-limiting nuts so that bit can be
retracted into the base of the router, clear of
the workpiece.

WARNING: To reduce the risk of injury, NEVER
adjust or remove the stop nut. Motor can
disengage resulting in loss of control.

CAUTION: Turn the router on before plunging the
cutter head into the workpiece.
1. Unlock the plunge mechanism by pulling down the
plunge lock lever
handes to plunge the router down as far as it will go,
allowing the bit to just touch the workpiece.
2. Lock the plunge mechanism by releasing the plunge
16
lock lever
3. Loosen the depth adjustment rod
thumb screw
39
6
into the base by aligning the groove
17
39
.
41
42
15
43
14
16
. Gently push down on the two
.
15
40
counterclockwise.
.
on the base. Slide
40
7
16
39
by turning the