Interlogix CDC4 Installation And Programming Manual page 104

Chapter 4: Menu reference
Unlock Output 1
Specify the output to be activated to unlock the door.
Unlock Output 2
This output is reserved for future use.
Door Input 1
Specify the input used to indicate if the door is open or closed. This is usually the
reed switch.
Door Input 2
Specify the input connected to the lock monitor on Strike, Maglock, and Drop bolt
lock types.
Forced output
Specify the output to be activated when an input is in a "Forced Door" condition,
for example, the door has been opened without a valid command.
Warning output
Specify the output to be activated during the "Warning time" when the shunt timer
is about to expire, for example, may be used to activate a buzzer above a door to
indicate the door needs to be closed.
DOTL output
Specify the output to be activated when an input is in a DOTL condition, for
example, the door left open after the shunt timer has expired.
RTE input
Specify the input that activates the request-to-exit function for the door being
programmed.
RTE functionality is programmed on the door's Shunt/Passback tab. See the
"RTE options" on page 107.
Interlocks
For more information on door interlocking, see the "Interlocking doors" on page
52.
Interlock doors
Tick the door numbers on the same CDC4 that will be prevented from being
accessed at the same time as the door being programmed.
External input 1, 2, 3
CDC4 can check up to three external inputs for interlocking. If an input is wired
up to an external controller door contact, then specify the input in one of the
98 CDC4 Door Controller Installation and Programming Manual