Table of Contents
Advertisement
2
Thin Type Ionizer
ER-VW
Selectable charge removal layout
Nozzle angle adjustment and joint layout can be selected as desired
Nozzle angle adjustment mechanism
The angles of the two nozzles can be adjusted within a range of approximately 190° by screwing down the ends of
the nozzles. After adjusting the angle, turn the ends of the nozzles to tighten them and secure them at that angle.
This allows the nozzle angles of the ER-VW to be adjusted easily after installation.
Includes angle
adjustment scale
Easy connection layout possible
The joint kit (optional) can be used to
connect up to a maximum of 5 ER-VW
units. The air supply part is connected via
quick connection joints, and the power
supply and input/output signals can also be
connected easily using connection cables
with connectors at both ends.
Multiple ER-VW units can be connected
together to provide charge removal layouts
that suit the target equipment.
Connection application example
High-frequency AC Method
Installation examples
Vertical
installation
example
Joint kit (1 kit required for each pair of devices)
1
Cable with connector on both ends
2
Air joint (for replacing plug with hexagonal hole)
End connector (Accessory)
1
2
Horizontal
installation
example
Used to connect power supply, input/output and ground.
Used to supply air.
Cable with connector (Accessory)
1
1
2
2
Certified by
NRTL
Air
supply
1
2
Advertisement
Table of Contents
