Suction Cup Lid Maintenance - DeVilbiss GTIPRO LITE Technical Bulletin

Parts Replacement/
Maintenance
SUCTION CUP LID
1. Remove drip free diaphragm (54).
Clean or replace. Make sure the vent
hole is kept clear. (see fig 34).
2. Remove cup lid gasket (53)
(see fig 35).
3. Make Sure the vent hole in the lid (56)
is clean and not blocked. (see fig 36).
4. It is recommended to replace the cup
gasket (53) with a new one to avoid
cup leaks (see fig 35).
5. Re-fit the drip free diaphragm. Position
the vent hole in the diaphragm 180°
away from the lid vent hole (see fig 34)
Chart 1 – Air Caps
PART No. FOR AIR
CAP
PRO-102-HV30-K
PRO-102-TE10-K
PRO-102-TE20-K
PRO-102-TE30-K
PRO-102-TE40-K
NOTE: When removing air cap from retaining ring, don't remove the Slip Ring (2) or Retaining Ring Seal (5) from
the Retaining Ring. Damage to the parts may occur. Slip ring and Retaining Ring seal are not available as
replacements. Simply wipe parts clean and reassemble with new or clean air cap.
Chart 2 – Fluid Nozzle Range & Fluid Needle
SPRAY GUN
PROPL (Pressure Feed)
PROSL (Suction Feed)
NOTE: When replacing the fluid nozzle or fluid needle, replace both at the same time. Torque to 18–20 Nm (160–
180 lbs.in). Do not over tighten the fluid nozzle. Use SN-28 (59) 10mm Spanner supplied with the gun and check
with a torque wrench.
© 2012 ITW Finishing Systems and Products
MARKING
TECHNOLOGY
ON AIR CAP
HVLP HV30
High Efficiency TE10
High Efficiency TE20
High Efficiency TE30
High Efficiency TE40
PART No. ON FLUID NOZZLE
PRO-205-085-K
PRO-205-10-K
PRO-205-12-K
PRO-205-14-K
PRO-200-16-K
PRO-200-18-K
PRO-200-20-K
RECOMMENDED
FLUID FEED
PRESSURE (bar)
Suction/Pressure
Suction/Pressure
Suction/Pressure
Pressure Only
Pressure Only
PART No. NEEDLE
PRO-320-085-10-K
PRO-320-12-14-K
13
AIR FLOW
INLET (L/min) @
2 bar
1.75 465
2.0 275
2.0 350
2.0 300
2.0 365
PRO-325-K