Changing The Sensor Battery - Kesseböhmer eTouch CONVOY Centro Operating Instructions Manual

CONVOY Centro – changing the sensor battery
The sensor uses a conventional CR2032 'button' battery. If the sensor does not respond to
pressure on the front panel, try changing the battery.
To change the battery remove the front sensor from the side panel of the cabinet.Take out the
old battery and replace it with another button battery the same size and voltage.
Note battery polarity!
The battery can be pushed out using a thin
wire, eg, a straightened paper clip.
In the event of a power outage, or failure of the eTouch system, the larder unit
can be opened manually. Users will notice slightly more opening resistance.
Note
Operating the CONVOY Lavido
Press the pressure switch in the Lavido handle to initiate automatic opening. Assisted opening
is activated by gently pulling the Lavido handle. Automatic closing can be activated either by
renewed pressure on the pressure switch in the Lavido handle or by starting to push the larder
unit shut.
CONVOY Lavido – pressure switch function
The pressure switch in the Lavido handle is tasked with initiating the opening and closing
movements. The pressure switch is activated when a battery is inserted and deactivated when
the battery is removed. Deactivating the pressure switch by removing the battery stops auto-
matic opening/closing by pressing. Opening/closing support is still operational.
22
l KESSEBÖHMER