1050 Built-In Battery - Lenovo 10w Hardware Maintenance Manual

Removal steps of the I/O board cable
When installing: Ensure that the connectors are attached firmly.

1050 Built-in battery

DANGER
Use only the authorized battery specified for the computer. Any other battery could ignite or
explode.
Important notice for replacing a battery
Attention: Lenovo has no responsibility for the performance or safety of unauthorized batteries, and provides no
warranties for failures or damage arising out of their use.
The Vantage app provides an automatic battery diagnostic test that determines if the built-in battery is defective. A
built-in battery FRU should not be replaced unless this diagnostic test shows that the battery is defective. The only
exception to this is if the built-in battery is physically damaged or a customer is reporting a possible safety issue.
If the Vantage app is not installed on the computer, the customer should download and install the program to diagnose
the built-in battery, before getting a non-physically damaged built-in battery replaced. Note that the replacement of a
physically damaged built-in battery is not covered by the warranty.
For access, remove these FRUs in order:
• "1010 Lenovo Integrated Pen (for selected models)" on page 36
• "1020 Pen dummy (for selected models)" on page 36
• "1030 LCD unit and LCD cable" on page 36
• "1040 I/O board cable" on page 38
.
Chapter 5 Removing or replacing a FRU
39