HP HPE Alletra 6010 Hardware Manual page 39

11. Provide Interface Assignment information for the following sections and click Next:
a) Interface Assignment:
For each IP interface, assign a subnet and a Data IP address within the specified network. For inactive interfaces, assign
the "None" subnet.
b) FC Interface (Fibre Channel arrays only):
This section displays the link status for all Fibre Channel ports. No configuration is required.
c) Diagnostic IP:
• Controller A diagnostic IP address within the specified network
• Controller B diagnostic IP address within the specified network
12. Provide the following Domain information and click Next:
a) Domain Name
b) IP address of your DNS Servers
You can list up to five DNS servers.
13. Provide the following Time information and click Next:
a) Time (NTP) Server
Type the hostname or IP address of your NTP server.
b) Time Zone
Choose the time zone the array is located in.
14. Provide Support information for the following sections and click Finish.
a) Email Alerts
• From Address
This is the email address used by the array when sending email alerts. It does not need to be a real email address,
but it must be in the proper address format. Include the group or array name for easy identification.
• Send to Addresses
HPE recommends that you check the Send event data to HPE Storage Support check box.
• Simple Mail Transfer Protocol (SMTP) server hostname or IP address
b) Diagnostic Analysis
Checking the Send Diagnostic Analysis data to HPE Storage Support check box enabless support to monitor your
array, notify you of problems, and provide solutions.
c) HTTP Proxy
Diagnostic Analysis and software updates require an HTTPS connection to the Internet, either directly or through a
proxy server. If a proxy server is required, check the Use HTTP Proxy and provide the following information to
configure the proxy server details:
• HTTP proxy server hostname or IP address
• HTTP proxy server port
• Proxy server user name
• Proxy server password
Note: The system does not test the validity of the SMTP server connection or the email addresses that you
provide.
15. Click Finish.
A pop-up window appears with status updates and then the Setup Complete window appears.
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
Install the HPE Storage Array 39