Call Command Behavior
Table 6-4
Call Command Behavior (continued)
Cisco ATA State and its Definition
DIALING: User is entering phone
number, which is parsed with the given
dial-plan rules
CONFIG: User configuring a
supplementary service in the United
States
CONFIG: User configuring a
supplementary service in Sweden
CALLING: Phone number is sent;
Cisco ATA is waiting for response from
the far end
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide H.323
6-8
Summary of Commands (Input Sequence and Actions)
R—Abort dialing, restart dial tone, and revert to PREDIAL state.
•
Invalid phone number—Abort dialing, plays fast-busy, and go to
•
WAITHOOK state.
*69—Call Return
•
#72v#—Forward unconditional to number specified in 'v'l (PacBell use 72#).
•
#73—Cancel any call forwarding (PacBell use 73#).
•
#74v#—Forward on busy to number specified in 'v' (PacBell does not enable
•
this service from the phone).
#75v#—Forward on no answer to number specified in 'v' (Pac Bell does not
•
enable this service from the phone).
*67—CLIR in the next call (if global profile is CLIP)
•
*82—CLIP for the next call (if global user profile is CLIR)
•
*70—Disable call waiting in the next call.
•
*99—Enable Fax Mode in the next call (non-standard).
•
Dial-tone—Revert to PREDIAL state.
•
•
Any complete configuration sequence—Carry out the configuration
command, restart dial-tone, and revert to PREDIAL state.
•
*21*v#—Forward unconditionally to number specified in 'v'.
•
*67*v#—Forward on busy to number specified in 'v'.
•
*61*v#—Forward on no answer to number specified in 'v'.
#21#—Cancel any call forwarding.
•
#67#—Cancel any call forwarding.
•
#61#—Cancel any call forwarding.
•
#31#—CLIR in the next call.
•
*31#—CLIR in the next call.
•
*43#—Enable call waiting in the next call (Sweden allows globally disable
•
call waiting).
#43#—Disable call waiting in the next call.
•
*69#—Call Return
•
(non-standard)*99#—Enable Fax Mode in the next call (non-standard).
•
All Regions:
R or any unrecognized sequence—Abort configuration, restart dial tone and
•
revert to PREDIAL state.
Any complete configuration sequence—Carry out the configuration
•
command, restart dial tone, and revert to PREDIAL state.
R—Cancel the outgoing call, restarts dial-tone, and revert to PREDIAL
•
state.
Chapter 6
Call Commands
OL-4008-01