Table of Contents
Advertisement
Available languages
Available languages
Troubleshooting (continued)
Symptom
LINE button lamp flashes when
not in use.
LINE 2 button lamp flashes
when not in use.
You hear an error beep and
can't store a speed dialing
number.
Speed dialing is incorrect.
The handset doesn't ring when
calling from the base phone.
The CHARGE lamp doesn't
light up when you replace the
handset to the base phone.
The battery pack has a shorter
life.
EN
36
Additional Information
Remedy
• Either the handset or the base phone is being used.
• The other telephone connected to the line is being
used.
• Make sure the telephone line cord is securely
connected to the telephone outlet.
• When you use only one line, this may happen if the
telephone is connected to the "L1 or L1/L2" jack. In
this case, connect it to the "L2/DATA" jack.
• Make sure you follow the procedure in storing the
number correctly (page 19).
• Make sure the number (including the tone and pause
digits) is fewer than 16 digits.
• Store a correct number after a confirmation beep (page
19).
• The battery may have little or no power. Charge the
battery for more than 8 hours (page 12).
• Raise the antenna of the base phone vertically.
• Move the handset closer to the base phone.
• Place the base phone away from noise sources (page
8).
• Wipe the charge terminals of the base phone and the
handset with a soft cloth or paper for better contact of
the charge terminals.
• Make sure the handset is placed on the base phone
properly.
• The power wasn't continuously supplied to the base
phone.
• The battery pack was charged less than 8 hours (due
to power failure, etc.).
Advertisement
Table of Contents
