Pioneer AVIC-F980DAB Operation Manual page 74

Appendix
Check USB
 The USB connector or USB cable has short-circuited.
— Check that the USB connector or USB cable is not caught
in something or damaged.
 The connected USB storage device consumes more than
maximum allowable current.
— Disconnect the USB storage device and do not use it. Turn
the ignition switch to OFF, then to ACC or ON and then
connect a compliant USB storage device.
HUB Error
 The connected USB hub is not supported by this product.
— Directly connect the USB storage device to this product.
No Response
 This product cannot recognise the connected USB storage
device.
— Disconnect the device and replace it with another USB
storage device.
Video resolution not supported
 Files that cannot be played on this product are included in
the file.
— Select a file that can be played.
USB1 was disconnected for device protection. Do not re-in-
sert this USB memory into the unit. Press reset to restart
USB memory.
(USB2 was disconnected for device protection. Do not re-in-
sert this USB memory into the unit. Press reset to restart
USB memory.)
 The USB connector or USB cable is short-circuited.
— Check that the USB connector or USB cable is not caught
in something or damaged.
 The connected USB storage device consumes more than
maximum allowable current.
— Disconnect the USB storage device and do not use it. Turn
the ignition switch to OFF, then to ACC or ON and then
connect a compliant USB storage device.
 The USB interface cable for iPod / iPhone is short-circuited.
— Confirm that the USB interface cable for iPod / iPhone or
USB cable is not caught in something or damaged.
Audio Format not supported
 This type of file is not supported on this product.
— Select a file that can be played.
74
iPod
Error-02-6X/-9X/-DX
 iPod failure.
— Disconnect the cable from the iPod. Once the iPod's main
menu is displayed, reconnect the iPod and reset it.
Error-02-67
 The iPod firmware version is old.
— Update the iPod version.
iTunes tagging
Error-8D
 Built-in FLASH ROM encountered an error.
— Turn the ignition switch to OFF and then to ON.
Tag store failed.
 Tag information cannot be stored in this product.
— Try again.
Already stored.
 This tag information is already stored in memory.
— Tag information can only be saved once for any given
song. Tag information cannot be saved for the same song
more than once.
Memory full. Connect iPod.
 The tag information is successfully stored. The flash memory
of this product has become full.
— The tag information on this product is transferred to the
iPod automatically when an iPod is connected.
Memory full. Tags not stored. Connect iPod.
 This product's flash memory used as the temporary storage
area is full.
— The tag information on this product is transferred to the
iPod automatically when an iPod is connected.
iPod full. Tags not transferred.
 Memory used for tag information on the iPod is full.
— Synchronize the iPod with iTunes and clean up the tagged
playlist.
Tag transfer failed. Reconnect your iPod.
 This product's tag information cannot transfer to the iPod.
— Check the iPod and try again.
Apple CarPlay
Attempting to connect to Apple CarPlay.
 Communication failed and the system is trying to connect.
 Wait for a while. Then, perform the actions below if the error
message is still displayed.
— Restart the iPhone.
— Disconnect the cable from the iPhone, and then connect
the iPhone again after a few seconds.
— Turn the ignition switch to OFF and then to ON.
If the error message is still displayed after performing the
above action, please contact your dealer or an authorised
Pioneer Service Station.
Bluetooth
Error-10
 The power failed for the Bluetooth module of this product.
— Turn the ignition switch to OFF and then to ON.
If the error message is still displayed after performing the
above action, please contact your dealer or an authorised
Pioneer Service Station.