Displaying The Current Memory Configuration - HP Vizualize,Visualize b2000 Supplementary Manual

2. Press downward on the ejector tabs located on each side of the DIMM connector. See
This raises the DIMM card for easy extraction.
Figure 2-9 Removing Memory Cards
3. Lift up evenly on the outside edges of the DIMM card to remove it. See Figure 2-9.
4. Install the remaining DIMM cards in the correct order. See Figure 2-4 or the system
label.
5. Replace the left side panel as explained in the section "Replacing the Left Side Panel" in
this chapter. Plug the power cord back in to the electrical outlet.
6. Verify that this removal was successful by "Displaying the Current Memory
Configuration" on page 23. Note that you can also use SAM and select the
Performance Monitor icon, then the System Properties icon, and in the window
that appears, select the tab labeled Memory. See the B2000 Owner's Guide for more
detailed instructions.
Displaying the Current Memory Configuration
The following sample screen output uses the memory command to show a memory
configuration table with properly-installed and configured memory.
To display the current memory configuration for your system, from the Information Menu
of the boot console interface, follow the directions in "Accessing the Boot Console Interface"
earlier in this chapter. Once you are in the Boot Console Interface Main Menu, type the
following at the prompt and press
Main Menu: Enter command> information
This places you in the Information Menu. From here, type the following at the prompt and
press :
Enter
Information Menu: Enter command> memory
The screen displays status and configuration information for the memory DIMMs installed
in your workstation. See the section "Memory Information Sample."
Chapter 2
Notches
:
Enter
Parts Replacement Procedures
Memory DIMMs
Figure 2-9
Ejector Tab
.
23