Advertisement
44
Loosen or tighten the feet to adjust the
level. A correct adjustment of the
appliance level prevents vibration, noise
and the movement of the appliance when
in operation.
When the Washer-Dryer is levelled, try to
rock it from corner to corner. If it does
rock, adjust the legs again until it is
levelled and does not rock.
Never place cardboard, wood or similar
materials under the machine to
compensate for any unevenness in the
floor. Install the machine on a flat hard
floor. Make sure that air circulation
around the machine is not impeded by
carpets, rugs etc.
Check that the machine does not touch
the wall or cupboard units.
14.3 Water Inlet
1.
Check the mouth of water
tap, if it is not flat, please
make it flat with file.
clockwise "DOWN"
counter clockwise "UP"
2.
Push down the slider, pull the
tap adapter out of the slider.
Loosen the 4 screws on the tap
3.
adapter, insert the mouth of the water
tap into the tap adapter, then,
tighten the 4 screws. (If the mouth of
the water tap is too big, please get the
bushing out of the tap adapter before
installation.
Screw
Bushing
4.
Push down the slider, fasten
it into the other side of the
tap adapter, let go the slider.
5.
After finishing the installation of the
water supply hose to the water tap,
connect the other side of the water
supply hose
with the water
inlet hole of
the machine.
6.
Turn in the plastic screw nut to
tighten the connection
of the water supply
hose with the
water inlet hole.
The inlet hose must not be lengthened.
If it is too short and you do not wish to
move the tap, you will have to purchase
a new, longer hose specially designed
for this type of use.
14.4 Water Drainage
The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink,
using the plastic hose guide supplied
file
with the machine.
Plastic screw
nut
Water inlet
hole
Turn in
Turn out
Advertisement
Chapters
