Output Specifications; Ozone Generator Construction; Troubleshooting; Countries That Participate In Manufacturing - Sota WOZ5 Manual

The Water O zonator Model WOZ5 Manual
3
battery, or an appropriate solar panel, purchase a Universal Power cord with Tip or
Center Positive polarity.

oUtpUt speCifiCAtions

greater than 200 mg/hr o
Anseros ozone Analyzer, model ozomat gm 6000-rt.

ozone generAtor ConstrUCtion

Uses fused Quartz glass and high grade Stainless-Steel ozone chamber. With
normal use, the chamber should last several years.

troUBleshooting

A troubleshooting guide for the Water ozonator is available at
www.sota.com/manuals. this guide is a great tool to check if you are experiencing
any issues with your unit.

CoUntries thAt pArtiCipAte in mAnUfACtUring

the manufacturing of the SotA Products is a global collaboration. the following
countries participate in the making of the Water ozonator (listed in alphabetical
order): Canada, China, Hong Kong, Malaysia, Spain, Taiwan, Thailand and the USA.

replACement ACCessories

to replace your accessories, please contact your supplier.

WArrAnty

the Water o zonator model Woz5 is covered by a two (2) year parts and labor
3
warranty on all internally mounted components. Please keep proof of purchase.
Warranty is void if the failure is due to abuse or negligence.

repAirs

Please contact your supplier for return instructions. for information about your closest
repair depot, contact repairs@sota.com or call 1.250.770.2023 or 1.800.224.0242 (toll-free
in canada & USA).
• The SOTA units are consumer products designed to be used as part of a Wellness Lifestyle • The SOTA units are not medical devices nor are they
intended to diagnose, treat or cure any medical or health condition • The use, safety or effectiveness of the SOTA units has not been approved by any
government agency • Please consult a health practitioner for any medical or health condition • Results using the SOTA Products will vary for each
person • Please note that all purchases of SOTA Products are deemed to be made in Penticton, BC, Canada •
© 2008-2022 SOTA Instruments Inc.
@ 1.5 lPm. measured using an ozone-in-Air gm
3
Made in China. Designed and Engineered in Canada.
Page 7 of 7 | www.sota.com