OLIMEX MOD-RFID1356 User Manual page 8

Downloaded from Elcodis.com electronic components distributor
where XX is a decimal number code of the occurred error. In general
the VICC error code bytes are propagated, along with some
additional MOD-RFID1356 specific error codes. See the table below
for error code definitions.
Error
code
1 Command code request not supported.
2 Request format not recognized.
3 Command option is not supported.
14 Generic error.
16 Specified block does not exist.
18 Specified block is locked.
19 Block write error.
20 Block lock error.
160 Power check failed.
256 VICC response timeout.
257 MOD-RFID1356 does not posses enough memory
to complete the requested operation.
258 VICC response has incorrect CRC.
Please consult the ISO15693 standard and your VICC datasheet for
more information about request and answer formats.
Example – read four 32-bit EEPROM words starting from word
number 2, addressed version, both timeouts set to 100ms,
addressing VICC UID with 7B8C0016010416E0 :
c100,100,20237B8C0016010416E00204
Example – read four 32-bit EEPROM words starting from word
number 2, non-addressed version:
c100,100,00230204
Example – write EEPROM word at address 0xA with value
0x11223344, addressed
7B8C0016010416E0 :
c100,100,20217B8C0016010416E00A11223344
Example – write EEPROM word at address 0xA with value
0x11223344, non-addressed version:
c100,100,00210A11223344
Below is a screen shot of command line session using HyperTerminal:
Description
version, addressing VICC UID with