Advertisement
Keep Warm Function
1 Press the ON/OFF button once and the button will light up and 100°C will be
shown on the display screen.
2 Select the required Keep Warm temperature between 70 – 95°C and then
press the Keep Warm button.
3 Once the water has reached the desired temperature, the Keep Warm function
will automatically switch on to maintain the water at the required temperature.
The button will flash whilst in the Keep Warm cycle and then stop once the
correct warming temperature is achieved.
• The Keep Warm function can only be selected for settings between 70°C to 95°C.
• The Keep Warm function can be set at any time during the heating cycle.
• The Keep Warm function is inoperable when 100°C is selected.
• After pressing the Keep Warm button do not press the ON/OFF button unless you want to reheat the water.
• The Keep Warm function will keep the water at the selected temperature for 30 minutes. After 30 minutes the kettle
will switch off automatically and go into standby mode.
• The Keep Warm function on it own will not heat water from cold.
• If the kettle is removed from the powerbase at any time the power will switch off automatically and go into standby
mode. Press the ON/OFF button to reset.
• To stop the Keep Warm function at any times just press the Keep Warm button again and the light will go out.
Changing From Centigrade (°C) to Fahrenheit (°F)
• The temperature shown on the display screen can be changed from
°C Centigrade to °F Fahrenheit by holding down the (+) button and the
Keep Warm button together for 2 seconds.
Mute Function
• The audible alert at the end of the heating cycle can be turned off by
pressing the Keep Warm button and (-) button at the same time for
2 seconds.
• To switch the audible alert back on press the Keep Warm button and
(-) button together until the audible alert beeps twice.
4
°C
70
75
80
85
90
95
100
x2
°F
158
167
176
185
194
203
212
Advertisement
