Advertisement
3.5
BATTERY CHARGING
Note: In DC operation, turn the Smart Throttle switch to the OFF position.
3.5.1 Connect the charging cables to the DC receptacle of the generator and then to the battery
terminals.
3.5.2 Connect the positive battery terminal to the positive charging cord. Refer to fig. 8.
Note: When charging a battery installed in a vehicle, disconnect the the vehicle’s grounding
battery cable. Reconnect the grounding cable after charging has been completed.
3.5.3 Start the engine.
3.6
STOPPING THE ENGINE
NORMAL USE
3.6.1 Switch off the connected equipment and disconnect the equipment plug. Refer to fig. 9.
3.6.2 Turn the engine switch to the OFF position. Refer to fig. 10.
3.6.3 Turn the fuel cap lever fully counter clockwise to the OFF position. Refer to fig. 11.
4. MAINTENANCE
4.1
CHANGING THE ENGINE OIL
4.1.1 Loosen the retaining screw and remove the left hand side maintenance cover. Refer to
fig. 12.
4.1.2 Remove the oil filler cap.
4.1.3 Thoroughly drain the used oil into a container. Refer to fig. 13.
4.1.4 Refill the the oil reservoir with the recommended oil and check the oil level.
4.1.5 Replace the left hand side maintenance cover and tighten the retaining screw.
4.2
AIR FILTER CLEANING
4.2.1 Repeat paragraph 4.1.1.
4.2.2 Press the latch tab on top of the air filter body and remove the filter cover. Refer to fig. 14.
4.2.3 Wash the filter in a non-flammable or high flash point solvent and dry it thoroughly.
4.2.4 Soak the element in clean engine oil and squeeze off the excess oil.
4.2.5 Replace the air filter.
4.2.6 Replace the cover by inserting the lower tabs and the latch tab.
4.2.7 Replace the left hand side maintenance cover and tighten the retaining screw.
01284 757500
fig. 12
fig. 13
Sole UK Distributor, Sealey Group, Bury St. Edmunds, Suffolk.
01284 703534
fig. 8
fig. 9
fig. 10
www.sealey.co.uk
Web
fig. 11
fig. 14
sales@sealey.co.uk
email
G1000E - 1 - 170106
Advertisement
