Summary of Contents for BaByliss MEN JAPANESE STEEL 7785U
Page 1
JAPANESE STEEL DIGITAL HAIR CLIPPER 7785U SAFETY CAUTIONS • Original instructions. Read these safety precautions carefully before using the unit! This appliance should only be used as described within this instruction booklet. Please retain for future reference. IMPORTANT CHILD SAFETY •...
Page 2
• The appliance’s charging stand and/or adaptor must be kept away from sources of water so that they do not fall into the water. • CAUTION! Keep the power cord and the appliance dry. For appliances with a removable power supply unit, remove the power cord before cleaning or using the appliance under running water.
Page 3
operation. • Special care is required when using the appliance close to the ears, eyes and face. • This appliance may be used by children aged from 8 and older and people with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction on the safe use of the appliance and understand the hazards involved.
Page 4
WEEE - END-OF-LIFE ELECTRICAL AND ELECTRONIC EQUIPMENTS In everybody’s interest and to actively participate in protecting the environment and human health: • Do not discard your products with your unsorted household wastes. • The WEEE (Waste electrical and electronic equipment) must be collected separately.
Page 5
Oiling Instructions • For optimum cutting performance, it is highly recommended to oil the blades after every use. • When using the oil for the first time, unscrew the cap and cut off the very end of the plastic tube with a pair of scissors. •...
Page 6
Preserving the batteries In order to maintain the optimum capacity of the rechargeable batteries, the appliance has to be fully discharged every 6 months approximately. Then recharge the appliance to full capacity, again for 3 hours. Mains Operation • Ensure the appliance is switched off. •...
Page 7
Comb Guides This appliance is supplied with 8 comb guides: Cutting Length Grade 9.5mm 13mm 16mm 19mm 22mm 25mm • To attach a comb guide, ensure the appliance is switched off. Position the comb guide over the front of the clipper blade and slide over the head. Push and click the rear of the comb guide into position.
Page 8
Clipping For an all over even cut: • Attach a comb guide as required – your clipper is supplied with 8 comb guides (grades 1-8). Each comb guide is labelled. • Switch the clipper on and the blades will start to move. •...
Page 9
Outlining • To tidy up the edges around your cut e.g. neckline and sideburns, detach the comb guides. • Hold the appliance upside down, so the front of the clipper is facing towards your head. • Hold the clipper straight on your sideburns or neckline and move the clipper downwards.
• To preserve your clipper’s efficiency, we recommend cleaning the blades regularly. After cleaning, switch the appliance on and oil the blades using a few drops of the lubricating oil supplied. Only use the lubricating oil supplied with the appliance as this is specifically formulated for high speed clippers and does not evaporate or slow the blades.
Page 11
If the product develops a fault due to defects in materials or manufacture after 12 months from the date of purchase, and within the guarantee period, Conair UK After Sales Service will repair or replace the product. Exclusions This guarantee will no longer be valid meaning that The Conair Group Ltd will not be liable to repair or replace your product where: 1.) The appliance has been used on a voltage supply other than that which is marked on the product, or advised within this instruction...
not apply if the product was purchased directly from The Conair Group Ltd. Guarantees on replacement products run from the original purchase date or date of delivery, whichever is later, and not from the date of replacement. This guarantee is an additional benefit and does not affect your statutory rights as a consumer.
Need help?
Do you have a question about the MEN JAPANESE STEEL 7785U and is the answer not in the manual?
Questions and answers