HP j6700 Installation Manual page 4

j6700/j6000 Graphics Cards
Your j-Class Workstation's PCI (Peripheral Connect Interface) assembly cage has three 64-bit, 4x,
3.3v, 66 MHz card slots, providing I/O expansion capabilities. See Figure 0-1.
Use the Primary Graphics Slot for the highest performance graphics card. Use the Secondary
Graphics Slot for the second graphics card and the remaining slot for any additional supported card.
Figure 0-1 j6700 PCI Card Slot Numbering
Primary Graphics Card Slot
Secondary Graphics Card Slot
NOTE: You will need a T-15 Torx driver or flathead screwdriver to remove the I/O slot bulkhead
screws.
Here are the steps required to remove a graphics card from your j6700 or j6000 computer.
1. Power down the system, and unplug the power cord from the electrical outlet.
2.
Open the side panel of the system unit. See your workstation's User's Guide for detailed instruc-