Controls And Display - Hover-1 FLEX Operation Manual

CONTROLS AND DISPLAY

PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
TURNING YOUR DEVICE ON/OFF
Power On: Take your Flex out of the box and place it flat on the floor.
Press the power button (located on the rear of your Flex) once.
Check the LED indicator (located in the center of your Flex). The
battery indicator light should be lit, indicating the Flex is powered on.
Power Off: Press the power button once.
MAT SENSOR
There are four sensors under the foot mats on your Flex.
When riding the scooter, you must ensure you are stepping on the
foot mats. Do not step or stand on any other area of your scooter.
The Flex may vibrate or spin in one direction, if weight and pressure
are applied to only one foot mat.
BATTERY INDICATOR
The display board is located in the middle of the Flex.
• Green LED Light indicates the hoverboard is fully charged.
• Red flashing LED light and beeping indicates low battery.
• Yellow light indicates the board is charging.
When the LED light turns red, please recharge the Flex.
6