Recording From The Radio - Sharp CD-BA2600H Operation Manual

Recording from the Radio

Before recording:
z When recording important selections, make a preliminary test to ensure that the
desired material is properly recorded.
z SHARP is not liable for damage or loss of your recording arising from malfunction
of this unit.
z The volume and sound controls can be adjusted with no effect on the recorded
signal (Variable Sound Monitor).
z For recording, use only normal tapes. Do not use metal or CrO tapes.
Recording can be operated in the TAPE 2 compartment. The TAPE 1 is for playback
only.
1
Tune in to the desired station. (See page 16.)
2
Load a cassette into the TAPE 2 cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the REC PAUSE
button.
Recording will be paused.
4
Press the / button on the
main unit or the TAPE 2 button
on the remote control to start re-
cording.
To interrupt recording:
Press the REC PAUSE ( ) button.
To resume recording, press the /
To stop recording:
Press the (TAPE ) button.
Note:
If you hear a whistling noise whilst recording an AM station, move the AM loop aerial.
Erase-prevention tab of cassette
tapes:
z When recording on a cassette tape,
make sure that the erase-prevention
tabs are not removed. Cassettes have
removable tabs that prevent accidental
recording or erasing.
z To protect the recorded sound, remove
the tab after recording. Cover the tab
hole with adhesive tape to record on
the tape without the tab.
Listening to the Radio (See page 16.)
( )
(TAPE 2 ) button.
Side A
Tab for side B Tab for side A
ENGLISH E-27