Canon PIXMA MP130 Easy Setup Instructions

1 Unpack and setup the machine.
1
Carefully remove all items from the box.
2
Remove the protective material.
3
Place the machine on a flat surface.
4
Remove all shipping tape and the protective sheet.
5
Lift the Scan Unit (1) until it locks into place, and remove the packing material
(2) from the Print Head Holder.
• Be sure to hold the machine by the side. Do not lift the machine by grasping the Paper Support Extension
or the Operation Panel.

Check the contents.

• Machine
• Print head
• Safety Instructions
• Quick Start Guide
The Setup CD-ROM contains the MP Drivers, as well as the electronic manuals User's Guide, Software
Guide and Photo Application Guide. Please read these guides.
• A printer cable is not included. You must purchase a USB cable (less than 10 ft./3 m) to connect your
machine to a computer.
• Please note that the items included with your machine may vary depending on the country of purchase.
2

Connect the power cord.

1
Connect the power cord.
(2)
(1)
2
If the message <PUT IN CARTRIDGE> appears, go to Step 3, "Install the print
head."

Start Here

Easy Setup Instructions

(1)
(2)
• Power cord
• Ink tanks
BCI-24 Black
BCI-24 Color
• Paper Support Attachment
• Easy Setup Instructions
• Setup CD-ROM
PLEASE WAIT
3

Install the print head.

1
Lift the Scan Unit until it locks into place.
2
Open the Paper Output Tray (1).
3
Open the Inner Cover (2).
• The Print Head Holder moves to the center.
Install the print head here (3).
(3)
(2)
(1)
5
Remove the protective cap.
Do not touch!
7
Lower the Lock Lever until it locks
into place.
4

Install the ink tanks.

1
Remove the orange protective
cap.
2
Insert the ink tanks.
• Insert the black ink tank into the right slot, and the color ink tank into the left slot.
IMPORTANT
• For correct printer operation, make sure ink tanks are secure in slots.
3
Close the Inner Cover (1) and the Scan
Unit (2).
4
If the LCD displays messages asking if
you replaced the ink tanks, press [
repeatedly to complete the installation.
5

Load the paper.

1
Open the Paper Support (1) and pull up the Paper Support Extension (2) until
it stops.
• If you are loading the legal-size paper, set the Attachment (3) to the Paper Support.
2
Load the paper with the print side face up.
• Ensure the paper stack does not exceed Paper Limit Mark.
3
Pinch and adjust the Paper Guide to the width of the stack.
(3)
(1)
(2)
Setup is complete.
If you are connecting the machine to a computer for use, see the reverse side for instructions on
installing the software.
Canon and BCI are registered trademarks and PIXMA is a trademark of Canon Inc.
All other products and brand names are registered trademarks or trademarks of their respective owners.
Specifications subject to change without notice.
HT7-0095-000-V.1.0 xx2004A
4
Raise the Lock Lever.
6
Insert the print head.
• Do not press it down.
Do not touch!
(2)
]
(1)
© CANON INC. 2004 PRINTED IN CHINA