HYDRALOOP H300 Home User & Installation Manual page 6

a Hydraloop system on the ground floor with a greywater gravity feed from the bath/shower from the
first floor. If the Hydraloop system is on the same level as the shower/bath an appropriate* liftpump
has to be installed to lift the water from the shower/bath up into the Hydraloop system.
*We recommend a DAB Novabox or Genix VT030. It is important that the pressure tube from the lift pump is
32mm to avoid excessive flow of water entering the Hydraloop unit.
If a Hydraloop unit is installed with the extra washing machine recycle option, the ideal place for
installation would be close to the washing machine, so that the washing machine liftpump can be
placed next or close to the washing machine. If the washing machine is placed on the same floor as
the Hydraloop but in another room, the lift pump can be installed close to the washing machine and
the greywater is lifted up, and from there flows into the Hydraloop unit.
Note: It is not allowed to combine one lift pump for both the washing machine recycle option
and the shower/bath water.
greywater input
wifi connection
mains backup water
pumped feed to lavatories
system can feed up to 4 toilets. It is advisable to integrate an expansion vessel somewhere in the the
line that feeds the lavatories. A second Hydraloop outflow valve feeds the washing machine. The
Hydraloop unit can have a third valve controlled water output which can supply recycled water to the
garden or pool.
V3.5 2020
WM recycle option
lift pump
on/off
mains electrical
connection
on/off
pumped feed to
pumped feed
to washing
machine
waste water to sewage
Hydraloop User & Installation Manual
The liftpump must be placed so that it is easily
accessible for maintenance. A 230 volt wire with
ground connection should be installed from the
Hydraloop unit to the washing machine liftpump
so the lift pump will receive power supply from
the Hydraloop unit and can be switched on/off.
Note: It is very important that the washing
machine lift pump is installed 'in line' with the
sewer, in such a way that the waste water can
go to the sewer via the overflow in the
liftpump, in case the lift pump is switched off
by the Hydraloop unit. The washing machine
lift pump is controlled by the software of the
Hydraloop unit. The unit will fully
automatically temporarily switch the liftpump
off so it will not receive the waste water from
the first two washing cycles. In this case the
bypass within the liftpump will release the
waste water to flow directly to the sewer.
The recycled water output from the Hydraloop
6