Advertisement
Replacement
Filter Replace
Please check the filter when using a period of time.
If the filter is covered by plenty of dust or the color
of filter is turned into filthy as the lable shows, the
airflow and the performance of the unit will be affected.
Warning : Do not turn on the unit without using a filter.
Filter Reload
1. Please turn off the unit first.
2. Unplug the unit before replacing the filter.
3. Please put on a mouthpiece and gloves.
4. Press the latches on both sides of the front cover and
pull out the cover.
5. Unpack a new filter, replace the dirty filter with the new one.
The yellow surface faces outward.
6. Replace the filter cover in right position.
7. Seal the dirty filter in a plastic bag, then suitably discard.
8. Discard the mouthpiece and the gloves.
9. Remember to wash your hands with cleanser.
Warning :
1. The filter can not be washed.
2. Please contact Whirlpool spare parts department should you want to buy a qualified filter.
Check up of UV lamp
Note: The UV Lamp may turn out after its life.
The Lamp can only be replaced by our service departments.
Never replace yourself with any other component that will
cause damage or danger.
To check the lamb:
1. Turn off the unit.
2. Remove the front cover and take out the filter.
3. Replace the front cover only. Turn on the unit and
press the ION / TiO
button to turn on the
2
photocatalyst function ( the light show turns to blue )
4. Check the UV light through sideholes of the front cover.
If the UV light is off then it should be replaced.
5.Turn off the unit, replace filter and front cover and call for service.
Note: To protect your eyes, don't look at the UV light for a long time.
7
The light yellow
side faces outward
Check though
the hole
Advertisement
