Cleaning Procedure - Parlux DIGITALYON Instructions For Use Manual

Perform regular hair dryer maintenance:
The hair dryer has a high power, so do not place it on dirty places (especially when the hair dryer is on)!! With the air that the
hair dryer sucks in, a large amount of dirt, hairsprays and hair is also sucked in. The hair dryer becomes clogged with dirt, the
performance of the hair dryer is reduced or it is damaged.
IN CASE THE INTERIOR OF THE DRYER IS CLOGGED WITH DIRT, THE WARRANTY DOES NOT COVER THE REPAIR OF THE
DRYER!!!
PERFORM THIS MAINTENANCE OF THE HAIRDRYER:
REGULAR CLEANING OF THE GRILL and the hair capture system
Turn off the device with the main switch and then disconnect it from the mains. Remove the grille (by unscrewing), clean it and
then put it back.

CLEANING PROCEDURE

HFS – HAIR FREE SYSTEM - A hair capture system is only effective if it is regularly maintained. Cleaning takes a few seconds, so
we recommend doing it every day.
Unscrew the filter counterclockwise from the back of the hair dryer (Figure 1-2).
Remove the HFS Hair Catcher (Figure 3-4).
Remove all hair from the part by simply twisting it counterclockwise (Figure 5).
Place the cleaned HFS back in the middle of the back of the hair dryer (6-7).
Clean the mesh filter of all dirt and screw it back onto the hair dryer in a clockwise direction (8-9-10). If this filter is very dirty,
it can also be washed with a brush and water, but it must be dried 100% before putting it back!
Declaration of Conformity
This product complies with the norms and standards of the European Union:
Directive 2014/30/UE and 2014/35/UE.
Disposal of the product
Electrical equipment with this symbol must not be disposed of together with municipal waste after use. In order
to properly dispose of the product, hand in any used electrical equipment at designated collection points, where
they will be accepted free of charge, or you can hand them in free of charge at the dealer when you are
purchasing a similar product.
The Class II or double insulation symbol indicates that this product has been designed so that no electrical
connection to earth is required. The production of these products was performed in such a way that in the event of
a malfunction there is no user contact with dangerous voltage. The packaging structure is made of insulating
material.