Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Makita DF332DWAE
Summary of Contents for Makita DF332DWAE
- Page 1 INSTRUCTION MANUAL Cordless Driver Drill DF332D DF032D Read before use.
-
Page 2: Specifications
SPECIFICATIONS Model: DF332D DF032D Drilling capacities Steel 10 mm Wood 28 mm Fastening capacities Wood screw 5.1 mm x 63 mm Machine screw No load speed High (2) 0 - 1,500 min Low (1) 0 - 450 min Overall length 154 mm 124 mm Rated voltage... -
Page 3: Cordless Driver Drill Safety Warnings
Personal Safety Use the power tool, accessories and tool bits etc. in accordance with these instructions, tak- Stay alert, watch what you are doing and use ing into account the working conditions and common sense when operating a power tool. the work to be performed. -
Page 4: Tips For Maintaining Maximum Battery Life
(gained from repeated use) replace causing fires, personal injury and damage. It will strict adherence to safety rules for the subject also void the Makita warranty for the Makita tool and product. MISUSE or failure to follow the safety charger. rules stated in this instruction manual may cause Tips for maintaining maximum serious personal injury. -
Page 5: Functional Description
Battery protection system FUNCTIONAL DESCRIPTION The tool is equipped with a battery protection system. This system automatically cuts off power to the motor to extend battery life. CAUTION: The tool will automatically stop during operation if the Always be sure that the tool is tool and/or battery are placed under one of the following switched off and the battery cartridge is removed conditions:... -
Page 6: Switch Action
Switch action Reversing switch action ► 1 . Switch trigger ► 1 . Reversing switch lever CAUTION: CAUTION: Before installing the battery car- Always check the direction of tridge into the tool, always check to see that the rotation before operation. switch trigger actuates properly and returns to CAUTION: Use the reversing switch only after... -
Page 7: Adjusting The Fastening Torque
Position of Speed Torque Applicable speed operation change lever High Heavy load- ing operation High Light loading operation To change the speed, switch off the tool first. Select the "2" side for high speed or "1" for low speed but high torque. Be sure that the speed change lever is set to the correct position before operation. - Page 8 For tool with shallow driver bit hole ASSEMBLY A=12mm Use only these type of driver B=9mm bit. Follow the procedure CAUTION: 1. (Note) Bit-piece is not Always be sure that the tool is necessary. switched off and the battery cartridge is removed before carrying out any work on the tool.
-
Page 9: Installing Hook
Hold the tool firmly with one hand on the grip and the Installing hook other hand on the bottom of the battery cartridge to control the twisting action. ► 1 . Groove 2. Hook 3. Screw Screwdriving operation The hook is convenient for temporarily hanging the tool. This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool housing on CAUTION: Adjust the adjusting ring to the... -
Page 10: Using Holster
Using holster CAUTION: Pressing excessively on the tool will not speed up the drilling. In fact, this excessive Optional accessory pressure will only serve to damage the tip of your drill bit, decrease the tool performance and shorten the CAUTION: When using the holster, remove a service life of the tool. -
Page 11: Maintenance
Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. OPTIONAL ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. - Page 12 Makita Corporation 885466A3 20171010 www.makita.com...