ABB HT570165 Operation Manual page 108

Table of Contents

Advertisement

NOTICE
© Copyright 2016 ABB. All rights reserved.
Disassembly and assembly
Disassembling and assembling
turbocharger
If two turbochargers are mounted on an engine, one with a left-hand
and one with a right-hand oil inlet, a pin can be fitted in the bracket as a
precaution against incorrect positioning. This pin (B) locates in a corre-
spponing groove in the foot of the bearing casing.
Fasten the cartridge group using fastening strips (51002), Verbus
Ripp® washers (51003) and nuts (51007) (also see the chapter enti-
tled Table of tightening torques).
Fasten the bearing casing (42001) using the fixing screws (C).
Tighten the fixing screws (C) to the torques listed in the following table.
**) For the assembly of the turbocharger on the engine support, the
threads of the screws and screw heads must be lightly oiled (assumed
coefficient of friction µ = 0.12 for the tightening torque).
Product
Hole in the bearing casing
[mm]
TPS44
Ø 17
TPS48
Ø 17
TPS52
Ø 21
TPS57
Ø 21
TPS61
Ø 25
Operation Manual / TPS44-F.. - TPS61-F..
8
8.3
Fixing screws
C [mm]
M16
M16
M20
M20
M24
Page 106
Tightening torques
[Nm] **)
230
230
455
455
780

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tps48-f32

Table of Contents