If The Plotter Waits Too Long To Plot A Nest; If The Plotter Performs The Cartridge Alignment Routine Unexpectedly; If The Bail (Black Metal Bar) Does Not Lower All The Way - HP Designjet 700 User Manual

Troubleshooting
Solving Miscellaneous Problems

If the Plotter Waits Too Long to Plot a Nest

Change the
Nest wait
If the Plotter Performs the Cartridge Alignment Routine
Unexpectedly
This is a normal plotter operation. The plotter will align the cartridge(s) every
time you replace, or even reseat, a cartridge, whether or not it is new.

If the Bail (Black Metal Bar) Does Not Lower All the Way

If the the bail (the black metal bar just inside the plotter's window) will not
lower all the way, check for obstructions underneath it.
Make sure the cutting carriage is pushed all the way to the right.
9-24
setting. See page 6-12.