Sound Adjustment - Toshiba 32P2300 Series Owner's Manual

Resetting the Picture Settings
• Use the menus: PICTURE and Picture Settings
• Use the item: Reset (select Yes and press OK)
Activating the Noise Reduction (NR)
If the receiving signal of MPEG is a mosquito
(grained) noise depending on the compression and
conversion, the picture is weak and the picture is
blurry, the picture may be improved when using this
function.
• Use the menus: PICTURE, Picture Settings and
Noise Reduction
• Use the items: Auto Clean, MPEG NR and DNR
• Use the modes: Low, Middle, High and Off
Adjusting the Colour Management
You can adjust the picture colour quality by
selecting from 6 base colour adjustments : Red,
Green, Blue, Yellow, Magenta or Cyan.
• Use the menus: PICTURE, 3D Colour
Management (On) and Base Colour Adjustment
• Use the items: Hue, Saturation and Brightness
Resetting the Base Colour Adjustment
• Use the menus: PICTURE, 3D Colour
Management (On) and Base Colour Adjustment
• Use the item: Reset
Using the Active Backlight Control
In order to improve screen visibility, the Active
Backlight Control sets the screen brightness
automatically during dark scenes.
• Use the menu: PICTURE
• Use the item: Active Backlight Control

Sound adjustment

Setting the MTS (Multi-channel TV Sound)
Auto mode
The MTS Auto mode automatically recognize
stereo/bilingual programmes depending on the
broadcast signal.
Mono mode
If you experience noise or poor reception of any
stereo/bilingual programme, set the MTS mode to
Mono.
Noise will be reduced and reception may improve.
• Use the menu: SOUND
• Use the item: MTS
Note:
If you experience noise with a particular programme
on whose channel reception is usually good, try setting
MTS mode to Auto, then press s to switch to
e Mono (monaural).
32P2300Series̲EN.indd 15 32P2300Series̲EN.indd 15
Selecting the Dual 1 or Dual 2 mode
You can hear only Dual 1 or Dual 2 sound selected,
whenever bilingual programmes are received.
• Use the menu: SOUND
• Use the item: Dual
Notes:
• When the MTS setting is in Mono mode, the Dual
menu is not selectable.
• The Dual menu setting status remains even if the TV
is turned off .
Selecting the stereo programmes
When a stereo programme is received, d Stereo
appears and press s .
• Use the modes: Stereo and Mono
Selecting the bilingual programmes
When a bilingual programme is received, j Dual
appears and press s .
Display
NICAM
Sub I sound
j Dual 1
Sub II sound
J Dual 2
e Mono
Main sound
Note:
These settings are not stored in the TV memory.
Selecting the monaural programmes
If sound distortion, interruptions or silence arises in
the low sound volume level, setting the e Mono 2
mode will mitigate the problem.
When a monaural programme is received, e Mono
appears and press s .
• Use the modes: Mono 1 and Mono 2
Note:
On some cases, the reception of stereo/bilingual
broadcasts may not be possible after switching on the
e Mono 2 mode.
Adjusting the sound Balance
• Use the menu: SOUND and Balance
• Use the button:  and 
Using the Sound Mode
Choose your preferred Sound Mode.
• Use the menu: SOUND, Advanced Sound
Settings
• Use the item: Sound Mode
• Use the modes: Dynamic, Natural and Clear
Voice
– 15 –
Sound to be heard
German stereo/
bilingual broadcast
Main sound
Sub sound
—
2013/03/19 19:43:41 2013/03/19 19:43:41