Example of network connection
Note
●
To use the network function, set each item in
[Network settings] and make sure to set [Network
control] to [On].
When it is set to [On], the power indicator light will be
orange under the power "Off" condition in the remote
control (stand-by state).
■
LAN Terminal connection
INTERNET
INTERNET
ROUTER
ROUTER
[RJ-45]
PC
Press the [MENU] button, choose
1.
<Network settings> and Press [ENTER].
2.
Make the network setting according to details
obtained from your System Administrator.
Notes
●
Use a shielded LAN cable to prevent the occurrence
of noise.
●
Make sure the broadband router or hub supports
10BASE-T/100BASE-TX.
●
Avoid touching the LAN terminal with your hands
or body. A static discharge could damage the
electronics.
Do not touch the LAN terminal or the metal part of the
LAN cable.
●
Consult your system administrator for instructions on
making the LAN connections.
For instructions on connection, consult r
1.
2.
When the display settings are the default settings
IP address
Subnet mask
Gateway
The computer can be used with the following
network settings.
[LAN]
IP address
Subnet mask
Gateway
The Network function of the unit is compatible with
PJLink Class 1. The following operations can be
performed from the computer using the PJLink protocol.
●
●
●
●
Supported commands
The commands used to control the unit with PJLink
protocol are as follows.
Computer operation
Turn on the computer.
Consult your system administrator for instructions
on making the Network settings.
Network configuration : Static IP
Static IP configuration.
192.168.0.8
255.255.255.0
192.168.0.1
192.168.0.9
255.255.255.0
192.168.0.1
PJLink protocol
Setting the Display
Querying the Display status
Notes
Set "Eco mode" to "Normal" when using the PJLink
protocol. (
See page 31)
Set "Eco mode" to "Normal" when using Multi
Monitoring & Control. (
See page 31)
English
35