Precision AM60PV Installation Manual

Precisi n
AM6O
MAGNETIC TUBULAR LATCH
1
Crossbore
Edgebore
o
o
1. Edgebore-Drill a 24mm hole into the edge of the door at
the desired height.
Crossbore-Drill hole(s) into the face of the door at a backset
of 60mm to the diameter(s) etc specified on the chosen
handles installation instructions.
4
4. Insert the plastic Strikebox/drilling template
o
edgebore hole and use as a guide to drill 2x
holes above and below edgebore hole.
o
Insert strikebox/drilling template into the 24mm hole
o
created in jamb (3a) and drill 2 x 3mm pilot holes above
o
and below 24mm hole.
INSTALLATION
All manuals and user guides at all-guides.com
GUIDE
Ezi - t housing cups
Strikebox/drilling template Strikebox/drilling template
Self Adhesive Self Adhesive
coverplates coverplates
Strikeplate Strikeplate
2
24mm
2. Insert the Strikemarker tool
(2A).
Close door tightly then press the pointed Strikemarker tool
into the jamb to mark a mounting position for the strikeplate.
5
o
into the
5. Use the 3mm pilot holes in door as a guide to drill
o
3mm pilot 2 x 24mm overlapping holes (above and below the
o
24mm hole) to a depth of approx. 5mm.
Repeat this step on the jamb to create 2 x overlapping
holes.
60mm
20mm 20mm
8x8mm 8x8mm
2a
3
(FIG.B) into the edgebore hole
3. Drill a
marked by the pointed
Use the pilot hole as a guide to drill a
the jamb to a depth of approx. 20mm.
6
6. Use a blade or pencil to mark vertical lines down the
edgebore
sides of the 3x overlapping
jamb
o
24mm
Use a Chisel to remove timber from the sides of the
overlapping
Precisi n
AM6OPV
TUBULAR PRIVACY BOLT
3a
o
3mm pilot hole into the jamb at the position
Strikemarker tool.
o
24mm hole into
6a
o
24mm holes on door and
(6a).
o
24mm holes where marked.