Sealey TPK252.V2 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Wear
Refer to
protective
instruction
manual gloves
1. SAFETY
Maintain the tow pole in good condition. If the tow pole is damaged, remove from service.
9
Check vehicle manufacturer's instructions to determine whether the vehicle is equipped
9
with proper tow fittings suitable for use with a tow pole. Also any check manufacturer's
special instructions for vehicles with automatic transmission or four wheel drive.
Use tow pole only on vehicles with standard tow eyes. DO NOT use transportation
9
'tie down' points.
Ensure the tow eyes and the areas of the vehicles to which the eyes are fitted are strong
9
and solid enough for towing. DO NOT use the tow pole if there is damage or heavy rust
around the fitting area and ensure the eyes are approximately the same height from the
ground.
Place an "ON TOW" notice in the back window or other visible location at the rear of the
9
towed vehicle. Attach a red marker (provided) to the centre of the tow pole.
The vehicle to be towed must be fully legal in respect of having the registration number
visible at all times, must have a valid road tax, insurance and relevant current DfT test
certificate. DO NOT tow a vehicle that lacks one or more of these requirements.
Towed vehicle must have the ignition on in order to operate lights, brake lights and
9
indicators. If these lights cannot be operated, you must fit a repeater trailer board to
towed vehicle. Contact your local Sealey stockist for information relating to approved
towing boards which must incorporate lighting and signalling equipment.
Ensure that the person in the towed vehicle is aware that, if servo brakes and/or power
9
steering are fitted, then braking and/or steering efforts will be very much higher than
normal when the engine is not running.
Read vehicle manufacturers instructions before use.
9
Maximum rolling load capacity 2000kg.
9
DO NOT exceed the rated capacity of the tow pole.
8
DO NOT exceed a maximum towing speed of 15mph.
8
DO NOT use the tow pole if damaged.
8
DO NOT tow vehicle if the steering lock cannot be disengaged.
8
DO NOT use the tow pole on a vehicle with defective braking system.
8
DO NOT tow an unmanned vehicle.
8
DO NOT force the tow pole to achieve a task it was not designed to perform.
8
DO NOT allow untrained persons to use the tow pole.
8
DO NOT operate the tow pole if any parts are missing as this may cause failure and
8
possible personal injury.
2. INTRODUCTION
i
2000Kg Rolling capacity tow bar ideal for the safe secure towing of motor vehicles. Connects to car towing eyes with secure attachment hooks.
Pole easily adjusted to match the towing eye orientation of both towed and towing vehicle. Breaks down for easy storage and is supplied with
storage bag.
3. SPECIFICATION
i
Model no: ............................................................... TPK252.V2
Tow pole length .................................................................1.8m
Maximum rolling load capacity .......................................2tonne
© Jack Sealey Limited
TOW POLE 2000KG ROLLING LOAD
CAPACITY
TPK252.V2
MODEL NO:
Original Language Version
TPK252.V2 Issue 2 (2) 05/08/21