Operation; Starting A Wash Cycle; Changing A Programme; At The End Of A Programme - Kenwood KDW60W14 Installation Instructions Manual

Operation

starting a wash cycle

1. Ensure the unit is connected to the mains power and the water supply is fully opened (water
pressure between 0.04MPa and 1.00MPa).
2. Open the door. Pull out the lower and upper baskets, load the dishes and push the baskets
back. It is recommended that the lower basket is loaded first, and then the upper basket.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close firmly
afterwards.
4. Close the dishwasher door. A click should be heard when the door is closed correctly. Do not
slam the door.
5. Press the on/ off button.
6. Press the programme button to select the wash cycle programme based on the loading and soil
requirements. Please refer to the section Wash Cycle Table.
7. The programme indicator will light up for the selected programme.
8. Press the start/pause button, the washing cycle will begin shortly.
If you open the dishwasher's door during the washing cycle and then close it, the
dishwasher will continue the current washing programme after 10 seconds.

changing a programme

To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to avoid water spillage before opening the door fully. Check if the unit has
dispensed the detergent or detergent tablet. This will depend on how long the washing cycle was
running for.
2. If the detergent dispenser lid is opened, we suggest you to allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, close the dishwasher door, press the start/pause
button to stop the programme, then press and hold the programme button for 3 seconds to
select the required new programme. Press the start/pause button again. The unit will start the
new washing cycle shortly.
4. The display window shows the state of the dishwasher.
a. "--:--" means the unit is on stand by mode.
b. "H:MM" and not flashing means the unit is on pause.
c. "H:MM" and flashing means the unit is running.

at the end of a programme

At the end of a programme, the dishwasher will beep.
The condensation strip helps to prevent the risk of steam damage to the worktop edging
above the dishwasher, it is advisable to leave the door closed until you are ready to unload
the crockery. However, you can also open the dishwasher door fully and wait until the
dishes and crockery are cool enough to unload. Do not leave the door only partially open.
25