Beckett CB50 Series Owner's Manual

AUTOMATIC CONDENSATE UNIT
Model: CB25*
23' LIFT

RULES FOR SAFE OPERATION

1. Carefully read the Owners Manual and rules for safe operation.
2. All wiring must conform to local codes. Use the National Electric Code if local code is nonexistent.
3. CAUTION! To reduce risk of electric shock disconnect from power supply before servicing, pull the plug on models which have
plug-in connections.
4. Do not handle the pump with wet hands or when standing in water as fatal shock could occur. Disconnect main power before
handling unit for ANY REASON!
5. Protect the power cable from coming in contact with sharp objects.
6. Do not kink power cable and never allow the cable to come in contact with oil, grease, hot surfaces or chemicals.
7. Make certain that line voltage conforms to the voltage specified on motor and nameplate.
8. WARNING! To reduce risk of electrical shock, connect only to a properly grounded grounding type receptacle.
Select a location for the pump. It should be
as near as possible to the air conditioning
coil. The pump must be level. The inlet
hole must be below the coil drain.
Carefully unpack the pump. Remove the
switch cover. Check each float rod for "free"
action.
Owners Manual
Keep For Future Reference
INSTALLATION OPERATION
CAUTION: Read rules for Safe Operation and Installation.
*Suffix denotes features
Example: CB25 1
Base Model UL Listed
Voltage:
1 = 115V; 2 = 230V: 4 = 460V;

INTRODUCTION

INSTALLATION

CB25
CB50
BECKETT CORPORATION
Irving, Texas
www.beckettus.com
Toll Free: 1-888-232-5388
© 2019 BECKETT CORPORATION All Rights Reserved
UL HT HTS CE
CE Listed
High Temperature Model, for use with Max. 212° F water.
High Temperature Model, for use with Max. 190° F water.
PRIMARY SWITCH
FLOAT
TERMINAL BLOCK
Model: CB50*
48' LIFT
COVER
OUTLET
SAFETY SWITCH
MOTOR
INLET
STAND
TANK
92357_Rev 01