HP Compaq Presario,Presario 2105 Reference Manual page 112

Conexant AT Commands (Advanced Users Only) (Continued)
Command
O
n
P
Q
n
S
n
S
n=v
T
V
n
W0
W1
W2
W3
X0
X1
X2
X3
X4
Z
+DR:
a
+DR=
n
Reference Guide
(Conexant)
0=go online, 1=go online and initiate retrain sequence.
Force pulse dialing.
0=enable result codes to DTE (default), 1=disable.
Select S-register
Set default S-register
Force DTMF dialing.
Report result codes: 0=short form (terse), 1=long form
(verbose) (default).
Report DTE speed (default).
Report line speed, error correction protocol, and DTE speed.
Report DCE speed.
Report DCE speed and error correction protocol.
Report CONNECT result code on connecting. Dial tone and
busy detection not reported.
Report CONNECT <text> result code on connecting. Dial tone
and busy detection not reported.
Report CONNECT <text> result code on connecting. Dial tone
and busy detection not reported.
Report CONNECT <text> result code on connecting. Dial tone
not reported, busy signal reported if detected.
Report CONNECT <text> result code on connecting. Dial tone
and busy signal reported if detected (default).
Reset to default configuration.
Select error control protocol: NONE=no data compression,
V42B=42 bis in both directions, ALT=MNP 5 compression.
0=disables extended format
1=enables.
n
as default.
n v.
to value
"+DR:"
Reference Information
intermediate result code,
7–3