Midea MP15EMC62 Service Manual page 8

PREPARATION OF SLEEVE ASSEMBLY
(optional)
• For an existing sleeve, measure the wall sleeve
dimensions.
• Install the new air conditioner according to
these installation instructions to achieve the
best performance. All wall sleeves used to
mount the new air conditioner must be in good
structural condition and have a rear grille that
securely attaches to the sleeve or the overhang
of the sleeve to secure the new air conditioner.
• To avoid vibration and noise, make sure the unit
is installed securely and firmly.
• When installing the sleeve, make certain there
is nothing within 20 inches of the back that
would interfere with heat radiation and exhaust
airflow. (See Fig. 2)
Fig. 2
• Refer to the installation instruction of sleeve
assembly for more details.
UNIT INSTALLATION
• Carefully remove shipping tapes from the front
panel. (See Fig. 3)
• Remove the front panel (see Fig. 4) by pulling
out the bottom to release the tabs (A). Then lift
up (B).
• Remove the shipping screw from the vent door.
(See Fig. 5)
• Rotate the vent control lever to either open or
close the vent door. (See Fig. 6)
Dimensions of air conditioner
w
www.mideaaircon.com 6