100 feet of the Terramite Street Sweeper. and machine is turned off. Then move valve handle 5. The Terramite Street Sweeper must not be operated 6 times in both directions to relieve residual pressure. if any person is within working range of the sweeper 15.
Terramite Street machine or the machine can hurt you. The answer to both Sweeper correctly, but you will have the assurance that questions is definitely YES, but not likely.
Page 5
In our constant reference to safety, we are well aware that lines or fittings while under pressure. If you suspect a we are creating a false impression that the Terramite Street leak, it can be quickly detected using a piece of cardboard Sweeper is a dangerous machine to operate.
Page 6
Some Never, Never, Nevers Emergency Procedures Never use the Terramite Street Sweeper for a job it wasn’t intended to do. Never use any other part of the machine Before working a hazardous area such as a hillside, take as work platform or a personnel carrier.
Starting the Terramite Street Sweeper. Do not attempt Relief Valve Settings. Do not change the relief valve to start or operate the Terramite Street Sweeper except settings. They are factory set for the best machine from the operator’s station. Never operate the controls from performance and safety.
Proper Towing Equipment. It is important that you use can tighten them down without exposing yourself to oncoming a truck that is capable of towing the trailer and the Terramite traffic. It is good practice to use a piece of tie wire to keep Street Sweeper, and that it is equipped with the proper tie- the handle from flying up.
Grease all pivot pins. Retract all deterioration, the following procedures should be performed cylinder rods. Use WD40 on all electrical parts and when the Terramite Street Sweeper will be idle for more areas inaccessible to regular grease. than 30 days: 7.
Change Oil and Filter As Specified Although your Terramite Street Sweeper is made of the Clean Cooling Fins and finest and most durable materials, it will only hold up if External Surfaces 50 hrs.
The preferred sealant is Loktite™ hydraulic thread All hoses are JIC. Hoses may be obtained from Terramite sealant with teflon paste. Corporation or any industrial rubber supplier or hydraulic shop.
The most important single thing you can do to increase the more metal, which also rusts. The rust and dirt make a life of the Terramite Street Sweeper is proper lubrication destructive grinding compound. Many people falsely blame of the pivot pins. The pivot pins should be lubricated with the manufacturer for their own neglect in lubricating the a good lithium based grease every four hours of operation.
If the problem involves a part of the machine, such as the key on the broom motor shaft has not sheared. engine, transmission, hydraulic pump, etc., that is manufactured by someone other than Terramite Corporation, Setting the Auxiliary Hydraulic System Main first check your service manual for more detailed information.
Capacity: 6 Ounces Motor Oil: SW 30 Wt. Detergent Service and Maintenance Points All references to "Left" or "Right" side of the Terramite Street Sweeper are stated as from the Operators seat facing forward. Anti-Freeze Mix Liquid cooled engines are very sensitive to the water/ antifreeze mix.
Factors for Longer Brush Life. Broom Storage 1. BROOM LEVEL The broom portion of the Terramite Street Sweeper should A broom not level with the sweeping surface may be stored away from direct sunlight. Prolonged exposure cut wafer life in excess of 50%.
Page 96
Read Operators Manual For Safety PARTS MANUAL & Decals Terramite Suggest Keeping a Current Journal on Replacement Parts for Quick Reference or Field Notes on Your Machine _________________________________________________________ _________________________________________________________ _________________________________________________________ _________________________________________________________ _________________________________________________________ _________________________________________________________ _________________________________________________________ _________________________________________________________ _________________________________________________________ _________________________________________________________ _________________________________________________________ _________________________________________________________ _________________________________________________________...
Page 106
However, when solely at our option, to the replacement or repair at the necessary, the manufacturer will act as your agent to premises of Terramite Corporation, 600 Goff Mountain Road, secure adjustment. Charleston, West Virginia 25356, or at a service facility...
Need help?
Do you have a question about the TSS38 and is the answer not in the manual?
Questions and answers