Page 1
STIH) STIHL FC 110 Instruction Manual Manual de instrucciones Warning! For safe operation follow all safety precautions in Instruction Manual - improper use can cause serious injury. Advertencia! Para su seguridad durante el manejo de este producto, siga siempre las precauciones de...
Emissions Control Warranty To receive maximum performance and Mounting the Loop Handle ..... 15 Statement ........42 satisfaction from your STIHL edger, it is Adjusting the Throttle Cable ... 15 Trademarks ........44 important that you read and understand Fitting the Cutting Blade ....16 the maintenance and safety precautions, 4-MIX Engine ........
Engineering improvements individual components. in different ways: STIHL’s philosophy is to continually A bullet marks a step or procedure Note or hint which is not essential improve all of its products. As a result, without direct reference to an...
Most of these safety precautions and Working with any edger can be warnings apply to the use of all STIHL Have your STIHL dealer show you how strenuous. If you have any condition that edgers.
Page 5
To reduce the risk of injury to your face The ignition system of your unit disease. In order to reduce the risk of STIHL recommends that you also wear produces an electromagnetic field of a whitefinger disease and carpal tunnel a face shield or face screen over your very low intensity.
Page 6
Protect your hands with when there is a danger of authorized attachments are useable for gloves when handling the head injuries. the STIHL edger, their use may, in fact, edger and the cutting tool. be extremely dangerous. Heavy-duty, nonslip gloves improve your grip and protect your hands.
Page 7
Fueling build up inside the gas tank depending on the fuel used, the weather conditions, Your STIHL edger uses an oil-gasoline Preparation for the use of the edger and the venting system of the tank. In mixture for fuel (see the chapter on...
Page 8
Move at least 10 feet (3 m) from spot of quantities of fuel. In order To do this with this STIHL leakage before starting. Take care not to to reduce the risk of fuel cap, raise the grip on the get fuel on your clothing.
Page 9
NIOSH/MSHA for the type of dust and / obstructions and objects, including the or fumes encountered. ground, because when the engine starts at starting-throttle, engine speed will be fast enough for the clutch to engage and turn the cutting tool. FC 110...
Page 10
Never use your edger as a hedge trimmer. Warning! Never divert discharge of material toward bystanders nor allow anyone near the area of operation. Use care in directing discharge to avoid glass enclosures, automobiles, and the like. FC 110...
Page 11
If the blade continues to trunks, stones or other such objects that intervals. If the behavior of the tool loosen, see your STIHL dealer. Do not could cause the edger to kick out or changes, stop the engine immediately, attach any blade to a unit without proper could cause damage to the blade.
Page 12
Improper use of any edger can cause properly or if nonapproved owner's manual. Have such work performed at your STIHL service shop serious or fatal personal injury. replacement parts were used, STIHL may deny warranty.
Working techniques Additionally, the daily maintenance Warning! schedule for your edger set forth in your STIHL Owner's Manual should be A worn or damaged muffler is a fire strictly followed. hazard and may cause loss of hearing. Check to see that the muffler is in good For any maintenance please refer to the condition.
Page 14
(3) is just touching the directed away from the machine and top of the soil in the normal working operator. position or breaks the surface of the soil no more than 0.2" (5 mm) (B). FC 110...
Page 15
Hold and guide the unit so that it is vertical. Cut at a rate which suits the cutting performance of the blade – do not apply force! Set the cutting rate for a normal walking pace. Do not push the blade into the ground. FC 110...
Adjusting loop handle to most handle. comfortable position: Release clamp screw (5). Move the loop handle along the drive tube as required - retighten the clamp screw. see "Guide to Using this Manual" FC 110...
(4) until the drive shaft is blocked. Apply combination wrench (5) to screw (6). Loosen screw clockwise (left-hand thread) and take it out. Remove retaining ring, plain washer and thrust washer. see "Guide to Using this Manual" FC 110...
English / USA 4-MIX Engine Fuel The STIHL 4-MIX engine features gas This engine is certified to operate on oil lubrication and must be run on a fuel unleaded gasoline and the STIHL two- mixture of gasoline and engine oil.
English / USA Fueling Use only STIHL two-stroke engine oil or Fuel mix ages equivalent high-quality two-stroke Only mix sufficient fuel for a few days engine oils that are designed for use work, not to exceed 3 months of storage.
# – normal run position (5) – the engine you must repeat the above steps. is running or can start. START (6) – the ignition is switched on – the engine can start. FC 110...
Need help?
Do you have a question about the FC 110 and is the answer not in the manual?
Questions and answers