Table of Contents
Advertisement
2 Installation of the hard disk drive
Step 3
Install the HDD in the bracket
Fix the HDD using 4 HDD fixing screws (accessories).
Tighten the screws in the order of ① to ④.
(Tightening torque: 0.49 N·m {0.36 lbf·ft})
HDD fixing screw (accessory)
④
(When replacing the hard disk drives)
When replacing a hard disk drive with another one, it is necessary to perform the removal process. In this case, do the
following.
Step 1
Perform the removal process of the hard disk drive.
(☞ Operating Instructions (PDF))
Step 2
Turn off the power of the recorder. (☞ Page 28)
Step 3
Pull out the HDD bracket from the inside of the front
cover of the recorder by referring to Step 2 of "Install the
hard disk drives" (☞ Page 13).
Step 4
Install the hard disk drive into the HDD bracket by referring
to Step 3 of "Install the hard disk drives".
14
③
②
HDD fixing screw (accessory)
(continued)
Step 4
Install the HDD bracket
Install the HDD bracket and tighten the HDD bracket screws
(×2) previously removed in Step 2 to secure.
(Tightening torque: 0.59 N·m {0.44 lbf·ft})
①
HDD bracket screw
Step 5
Fit the front cover as it was.
Attach the front cover by following Step 1 in reverse order.
The tightening torque of the front cover fixing screw is
0.59 N·m {0.44 lbf·ft}.
Step 5
Insert the HDD bracket with the hard disk drive into the
HDD slot by referring to Step 4 of "Install the hard disk
drives".
Step 6
Turn on the power of the recorder. (☞ Page 27)
→ New hard disk drive will be formatted automatically.
→
When the formatting is completed, the hard disk
drive will become operable.
When the hard disk drive is formerly used for record-
ing, perform the link process (☞ Operating
Instructions (PDF)) on the "HDD management" page.
The status of hard disk drive can be checked on the
setup menu - the "Maintenance" page - the "HDD
information" tab. (☞ Operating Instructions (PDF))
Advertisement
Table of Contents
