Table of Contents
Advertisement
Control Commands
You can control this projector by sending commands via CONTROL port or LAN port.
System Requirement
CONTROL port
Connection Cable
Communication Mode
Baud Rate
Character Length
Parity Check
Stop Bits
Flow Control
LAN port
Connection System
Port
Control Command
Function
Power
Source
Selection
Audio
Control
76
9-pin RS-232-C Cable (Crossover)
RS-232-C asynchronous, half-duplex communication
19200 bps
8 bit
None
2 bit
None
TCP/IP Connection
33336
Read/
Operation
Write
W
Power On
W
Power Off
R
Power Status
W
Computer1
W
Computer2
W
HDMI
W
Video
W
S-Video
R
Current source
W
Mute On
W
Mute Off
R
Mute Status
W
Volume +
W
Volume -
R
Volume Status
Command (ASCII)
POWER=ON<CR>
POWER=OFF<CR>
GET=POWER<CR>
INPUT=DSUB1<CR>
INPUT=DSUB2<CR>
INPUT=HDMI<CR>
INPUT=VIDEO<CR>
INPUT=S-VIDEO<CR>
GET=INPUT<CR>
MUTE=ON<CR>
MUTE=OFF<CR>
GET=MUTE<CR>
RC=VOL_P<CR>
RC=VOL_M<CR>
GET=AVOL<CR>
Note
Enable during
"Standby" state.
Enable during any
power state.
[Warming up]
g:POWER=OFF2ON
[Cooling down]
g:POWER=ON2OFF
Advertisement
Table of Contents
