Mitsubishi Electric MR-CX402EJ Operating Instructions Manual page 5

Adjustment and affixing
Turn the adjustable legs to get
them to touch the floor, then affix.
Refrigerator/front lower
Before adjusting, please pull the leg cover to the front and remove it.
※
Please fix the tilt by adjusting the legs.
●
Please adjust the adjustable leg as the following picture to level the refrigerator.
If the left side
of the door
is sagging
Raise the right side
After several days from installing, it may sink to the floor by weight.
※
Please re-adjust the adjustable legs again.
When the tilt cannot be corrected
with the adjustable legs.
If installed in a corner of a room,
there are times when one side of
the back legs sinks into the floor.
When that happens, please make
adjustments in the rear with
caster support (separately sold)
or a strong board underneath
(normally, the thickness of the
board should be 2 – 3 mm.)
After adjusting please insert the toe grille.
●
(Toe grille included in the refrigerator)
Adjustable leg
Fix firmly by adjustable legs
in the level and strong floor.
The refrigerator may move and
Always follow
cause injury.
instructions
If the right side
of the door
is sagging
Right Left
Raise the left side
For the caster support, please contact
to the shop where you purchased.
Model No.: MRPR-03CS
Please insert in parallel until
the cover hit in depth.
Toe grille
Toe grille
Adjustable leg
(to provide half-opened
door/noise/move/vibrate)
Turn in the direction of
the arrows and lower
the adjustable legs to
place on the floor.
Caster
Keep the front at a slightly
higher angle. This makes
closing the door easier
and prevents the door
from partially opening.
Rear support
Caster support
or strong board
Caster
Start using
It takes time to cool down.
●
Put in warm food items or ice
cream after the refrigerator has
been adequately cooled down.
Keep opening and closing of
the door for to a minimum,
and open in a short time.
In the summer, it will take
approx. 24 hours to make
the first batch of ice.
It may smell of plastic.
●
The smell will gradually disappear.
Please be ventilation of the
room not to filled a bad odor.
When the refrigerator is in cooling
●
mode the following may occur
(also occurs during summer).
The side will be hot to radiate
outside of the refrigerator for cooling.
Operating noise will loud due
to the compressor is high-speed
operation.
Preparation for the earthquake
We recommend you to fix
●
in the strong places such
as walls, pillars.
Please consult with the store
where you purchased for fall
prevention belt for the refrigerator
(Sold separately).
Model No.: MRPR-02BL (2 pcs.)
Fixed via belt with the
supports (2 places)
Do not damage the
refrigerant circuit (piping)
of the refrigerator;
do not drive in screws.
Because a flammable
refrigerant (gas) is used,
Do not do
there is the danger of
igniting or explosion.
Use in hot spring areas
Corrosion control treatment must be
applied for the refrigerant circuit (pipe)
due to generation of corrosive gases.
Contact the retail store where you
purchased the refrigerator.
5