Fujitsu F2 MC-16L Operation Manual page 16

■ Setting of the emulator-dedicated power supply
According to whether the emulator-dedicated power supply on the evaluation MCU is available to
be used, set the setting of the emulator-dedicated power supply.
Using the emulator-dedicated power supply setting jumper on the adapter board, set the tool interface
power supply on the evaluation MCU to operate with the user power supply (UV
opment tool power supply (+5 V).
On an evaluation MCU that has a emulator-dedicated power supply, the development tool power
supply must supply power to the evaluation MCU as a tool interface power supply.
For an evaluation MCU that has an emulator-dedicated power supply, set the development tool pow-
er supply (+5 V). For an evaluation MCU that does not have a emulator-dedicated power supply, set
the user power supply (UV
For details about an evaluation MCU with a emulator-dedicated power supply, see the evaluation
MCU hardware manual of the relevant product, or contact the sales dept. or support dept.
Figure 13 shows the emulator-dedicated power supply setting jumper. Table 6 lists the settings of the
jumper.
12
CC
*1: Emulator-dedicated power supply setting jumper
*2: Power supply setting jumper of user port 0 (For details, see "■ Setting of the user
port power supply").
*3: Power supply setting jumper of user port 1 (For details, see "■ Setting of the user
port power supply").
Figure 13 Emulator-dedicated power supply setting jumper
Table 6 Settings of the emulator-dedicated power supply setting jumper
Emulator-dedicated power supply pin
Available
Not available
1).
S1 VCC SEL
TOOL VCC*
P0V*
P1V*
C B A
TOOL VCC: B-C short-circuited (+5 V)
TOOL VCC: A-B short-circuited (UV
CC
1
2
3
Setting of VCC SEL (S1)
1) or the devel-
1)
CC