Table of Contents
Advertisement
The AT-HDVS-150-TX provides auto-switching capability between HDMI IN 1 and HDMI IN 2, which will automatically
switch the input to the most recently-connected or powered source when a source is disconnected. For example,
if the connection sequence is HDMI 2 > HDMI 1, and a source is disconnected from HDMI 1, then the AT-HDVS-
150-TX will automatically switch to the HDMI 2. Auto-switching mode is enabled or disabled through the on-screen
display (OSD) menu system, and is enabled (On), by default.
NOTE: Auto-switching is triggered by a Hot-Plug Detect (HPD) event. If HPD is not detected,
then AT-HDVS-150-TX will not switch inputs. VGA does not support HPD. Therefore, the VGA port
cannot be used in the auto-switching cycle.
1. Connect a category cable from the HDBaseT OUT port on the AT-HDVS-150-TX to the HDBaseT IN port on the
AT-HDVS-150-RX using a category cable (CAT-5e or better). The category cable should not exceed 230 feet (70
meters) in length.
The AT-HDVS-150-RX must be connected to the AT-HDVS-150-TX, in order to manage auto switching.
AT-HDVS-150-TX
HDBaseT IN
FW
2. Connect an HDMI cable from the HDMI OUT port on the AT-HDVS-150-RX to a display.
RX TX
L
R
HDMI OUT
AUDIO OUT
RS-232
3. Press the MENU button on the front panel of the AT-HDVS-150-RX to display the on-screen display (OSD) menu
HDBaseT IN
FW
system.
RX TX
L
R
HDMI OUT
AUDIO OUT
RS-232
AT-HDVS-150-TX / AT-HDVS-150-TX-PSK
Input Auto Switching
+
DC 48V
PW
LINK
MENU
V
V
to Display
+
DC 48V
PW
LINK
MENU
V
V
Solution Setup and Configuration Guide
AT-HDVS-150-RX
HDBaseT IN
FW
L
R
HDMI OUT
AUDIO OUT
+
DC 48V
RX TX
PW
LINK
RS-232
MENU
V
V
15
Advertisement
Table of Contents
