Sharp KB-6021MS Service Manual page 31

Microwave drawer
Hide thumbs Also See for KB-6021MS:
Table of Contents

Advertisement

SWITCH ANGLE REMOVAL
(Locate either the right or left switch angle)
. Follow the Microwave Drawer disassembly as previously stated
2. Open the drawer and keep it open.
3. To discharge the high voltage capacitor, wait for 60 seconds.
4. To remove switch, remove screw () holding switch to switch angle
(Fig. S-1).
5. To replace switch angle, remove bottom cover and turn drawer on
its back, then remove the screw holding the switch lever on
either right or left (Fig. S-2).
6. Proceed in reverse to reinstall.
ACTUATOR REMOVAL/ADJUSTMENT
. Follow the Microwave Drawer disassembly as previously stated
2. Open the drawer and keep it open.
3. To discharge the high voltage capacitor, wait for 60 seconds.
4. Locate either the right or left actuator and remove the 2 screws holding the actuator to the door support
angles.
5. Relpace with the new actuator (Fig. A-3).
Actuator adjustment
6. It is very critical that proper adjustment is made to actuator.
7. Adjust each actuator to fully depress ("0" gap) switch lever switches on left and right side (Fig. A-4).
NOTE: If this adjustment is not adjusted correctly, it will effect the performance of the Auto Drawer.
SWITCH ANGLE REMOVAL/ADJUSTMENT
Right
Fig. A-3
Fig. S-2
3
Fig. S-1
Left
Fig. A-4
KB-6021MS
KB-6021MK
KB-6021MW

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kb-6021mkKb-6021mw

Table of Contents