Related Manuals for Beko WTG720M1W
Summary of Contents for Beko WTG720M1W
- Page 1 Washing Machine User Manual WTG720M1W Document Number= 2302061182_EN / 02-05-17.(12:06)
- Page 2 This product was manufactured using the latest technology in environmentally friendly conditions.
-
Page 3: General Safety Instructions
General safety instructions This section includes security instructions which may help prevent the injuries and material damage risks. All kinds of warranties shall be invalid if these instructions are not observed. 1.1 Life and property safety Never place the product on a carpet-covered floor. Electrical parts will get overheated since air cannot circulate from under the device. -
Page 4: Hot Surface Safety
Electrical products are dangerous for the children. Keep the children away from the product when it is in use. Do not allow them to play with the product. Use child lock to prevent children from intervening with the product. Do not forget to close the loading door when leaving the room where the product is located. -
Page 5: Important Instructions For Environment
Important instructions for environment 2.1 Compliance with WEEE Directive This product complies with EU WEEE Directive (2012/19/EU). This product bears a classification symbol for waste electrical and electronic equipment (WEEE). This product has been manufactured with high quality parts and materials which can be reused and are suitable for recycling. - Page 6 Complying Commission Delegated Regulation (EU) No 1061/2010 Supplier name or trademark Beko WTG720M1W Model name Rated capacity (kg) A+++ Energy efficiency class / Scale from A+++ (Highest Efficiency) to D (Lowest Efficiency) Annual Energy Consumption (kWh) 0.92 Energy consumption of the standard 60°C cotton programme at full load (kWh) 0.59...
-
Page 7: Appropriate Installation Location
4.1 Installation • Apply to the nearest authorized service agent for the installation of your product. • Preparation of the location and electrical, tap water and waste water installations at the place of installation is under customer's responsibility. • Make sure that the water inlet and discharge hoses as well as the power cable are not folded, pinched or crushed while pushing the product into its place after installation or cleaning procedures. • Make sure that the installation and electrical connections of the product are performed by authorized service. Manufacturer shall not be held liable for damages that may arise from procedures carried out by unauthorized persons. -
Page 8: Connecting Water Supply
4.1.4 Connecting water supply The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 1 MPa). It is necessary to have 10 – 80 liters of water flowing from the fully open tap in one minute to have your machine run smoothly. Attach a pressure reducing valve if water pressure is higher. CAUTION: Models with a single water inlet should not be connected to the hot water tap. In such a case the laundry will get damaged or the product will switch to protection mode and will not operate. CAUTION: Do not use old or used water inlet hoses on the new product. -
Page 9: Adjusting The Feet
4.1.6 Adjusting the feet CAUTION: In order to ensure that the product operates more silently and vibration-free, it must stand level and balanced on its feet. Balance the machine by adjusting the feet. Otherwise, the product may move from its place and cause crushing and vibration problems. -
Page 10: Important Fitting A Different Plug
If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate plug fitted. Destroy the old plug, which is cut off as a plug with a bared cord could cause a shock hazard if inserted into a socket elsewhere in the house. -
Page 11: Initial Use
4.1.8 Initial use Before starting to use the product make sure that the preparations are made which are in line with the “Important Safety and Environment Instructions” and the instructions in the “Installation” section. To prepare the product for washing laundry, perform first operation in Drum Cleaning programme. -
Page 12: Sorting The Laundry
4.2 Preparation 4.2.1 Sorting the laundry * Sort laundry according to type of fabric, color, and degree of soiling and allowable water temperature. * Always obey the instructions given on the garment tags. 4.2.2 Preparing laundry for washing • Laundry items with metal attachments such as, underwired bras, belt buckles or metal buttons will damage the machine. -
Page 13: Using Detergent And Softener
4.2.6 Using detergent and softener When using detergent, softener, starch, fabric dye, bleacher and decolorant, descaling agents; read the manufacturer's instructions written on the package and follow the dosages specified. Use measuring cup if available. The detergent drawer is composed of three compartments: – (1) for prewash – (2) for main wash... - Page 14 Using liquid detergents If the product contains a liquid detergent cup: • Put the liquid detergent container into the compartment no “2”. • If the liquid detergent lost its fluidity, dilute it with water before putting it into the detergent container. If the product does not contain a liquid detergent cup: • Do not use liquid detergent for the prewash in a programme with prewash. • Liquid detergent stains your clothes when used with Delayed Start function. If you are going to use the Delayed Start function, do not use liquid detergent.
-
Page 15: Tips For Efficient Washing
4.2.7 Tips for efficient washing Clothes Delicates/ Light Colours and Black/Dark Colours Woolens/ Whites Colours Silks (Recommended (Recommended (Recommended temperature (Recommended temperature temperature range temperature range range based on soiling level: range based on soiling level: based on soiling level: based on soiling 40-90 cold -40... -
Page 16: Operating The Product
4.3 Operating the product 4.3.1 Control panel 2 4 3 1000 1 - Progr 2 - Spin Speed Indicator LEDs 6 - Programme Follow-up LEDs 3 - Child Lock Enabled LED 7 - Start / Pause Button 4 - Door Lock Enabled LED 8 - Delayed Start Setting Button 5 - Delayed Start Indicator LEDs 9 - Spin Speed Adjustment button... -
Page 17: Programme And Consumption Table
4.3.4 Programme and consumption table programme Cottons 90° 2.45 1600 Cottons 40° 1.10 1600 Cottons 20° 0.58 1600 Cottons 60° with Prewash 106 1.95 1600 Cottons Eco 60° 50.6 0.92 1600 Cottons Eco 40° 0.72 1600 Synthetics 40° 1200 Synthetics 20° 0.26 1200 Daily Quick 30°... -
Page 18: Main Programmes
4.3.5 Main programmes Depending on the type of fabric, use the following main programmes. • Cottons Use this programme for your cotton laundry (sheets, bedlinen, towels, bathrobes, underwear etc.). Your laundry will be washed with vigorous washing action for a longer washing cycle. -
Page 19: Special Programmes
CAUTION: Do not wash the items apart from duvets such as carpets, rugs and etc. in the machine. Permanent damage occurs in the machine. DownWear 40° • Use this programme to wash your coats, vest, jackets etc. containing feathers with a "machine-washable"... -
Page 20: Speed Selection
4.3.8 Speed selection Whenever a new programme is selected, the recommended spin speed of the selected programme is displayed on the spin speed indicator. To decrease the spin speed, press the Spin Speed Adjustment button. Spin speed decreases gradually. Then, depending on the model of the product, "Rinse Hold" and "No Spin"... -
Page 21: Starting The Programme
Changing the delayed start period If you want to change the time during countdown, you will need to cancel the programme and set the delay time again. Cancelling the Delayed Start function If you want to cancel the delayed start countdown and start the programme immediately: 1. -
Page 22: Switching The Machine To Pause Mode
4.3.12 Progress of programme Progress of a running programme can be followed from the Programme Follow-up indicator. At the beginning of every programme step, the relevant indicator light will turn on and light of the completed step will turn off. You can change the speed settings without stopping the programme flow while the programme is running. -
Page 23: Cancelling The Programme
4.3.15 Cancelling the programme To cancel the programme, turn the Programme Selection knob to select another programme. Previous programme will be cancelled. End / Cancel light will flash continuously to notify that the programme has been cancelled. Your machine will end the programme when you turn the Programme Selection knob;... -
Page 24: Maintenance And Cleaning
4.4 Maintenance and cleaning Service life of product extends and frequently experienced problems will be reduced if it is cleaned at regular intervals. 4.4.1 Cleaning the detergent drawer Clean the detergent drawer at regular intervals (every 4-5 washing cycles) as shown below in order to prevent accumulation of powder detergent in time. -
Page 25: Draining Remaining Water And Cleaning The Pump Filter
4.4.5 Draining remaining water and cleaning the pump filter The filter system in your machine prevents solid items such as buttons, coins and fabric fibres clogging the pump impeller during discharge of washing water. Thus, the water will be discharged without any problem and the service life of the pump will extend. -
Page 26: Troubleshooting
Troubleshooting Problem Reason Solution Programme does not start Start / Pause / Cancel button was not pressed. • *Press the Start / Pause / Cancel button. after closing the door. It may be difficult to close the loading door in case • Reduce the amount of laundry and make sure of excessive loading. - Page 27 Problem Reason Solution Washing takes longer time than Water pressure is low. • Machine waits until taking in adequate specified in the manual.(*) amount of water to prevent poor washing quality due to the decreased amount of water. Therefore, the washing time extends. Voltage might be low.
- Page 28 Problem Reason Solution Washing performance is poor: Regular drum cleaning is not applied. • Clean the drum regularly. For this, please Oily stains appeared on the see 4.4.2. laundry. (**) Washing performance is poor: Odours and bacteria layers are formed on the • Leave the detergent drawer as well as Clothes smell unpleasantly.
- Page 29 Problem Reason Solution Too much foam forms in the Improper detergents for the washing machine are • Use detergents appropriate for the washing machine. (**) being used. machine. Excessive amount of detergent is used. • Use only sufficient amount of detergent. Detergent was stored under improper conditions.
- Page 30 flaps, handles or Should you experience any difficulty in container lids. obtaining service please contact the Beko Customer Help-Line. including but not limited to, ice trays, scrapers, cutlery baskets, filters and light bulbs.
- Page 31 Instruction Booklet and service can be obtained at a charge. Label affixed to the appliance) Should you experience any difficulty in obtaining service please contact the Beko Model No: Customer Help-Line. Serial No: Tel: 0845 600 4911 or...
- Page 32 BEKO plc. Beko House, 1 Greenhill Crescent, Watford Herts WD18 8QU...
Need help?
Do you have a question about the WTG720M1W and is the answer not in the manual?
Questions and answers