Bush DW9SLINTW Instruction Manual page 36

Product support
Help is always at hand
Automatic Fault Warnings
TROUBLE CODE
P1 P2
PRACTICAL INFORMATION
1.When the machine isn't in operation:
• Disconnect the plug and close the tap.
• Leave the door slightly open to prevent odur formation.
2.Select the dry option to remove water droplets.
3.Place dishes in the machine properly to achieve the best energy consumption, washing and
drying performance. Please see the programme and consumption table for more information.
4.Rinse dirty dishes before placing them in the dishwasher.
5.Only use the Prewash programme when necessary.
6.Do not place the machine near a refrigerator because it will reach high temperatures.
7.If the machine is located in an area that is at risk of freezing, close the tap, disconnect the inlet
hose from the tap and drain the water inside the hose and the machine completely.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Using your Dishwasher
36
POSSIBLE FAULT
P3 P4
Insufficient water
Continuous water input
Inability to discharge
water
Faulty heater and
heater senor
Overflow
Faulty electronic card
WHAT TO DO
Make sure the water inlet tap is open and water is
flowing.
Separate the inlet hose from the tap and clean the
filter of the hose.
Contact for service if the error continues.
Close the tap and contact for service.
Water discharge hose and filters may be
clogged.
Cancel the programme.
If the error continues, contact for service.
Contact for service.
Contact for service.
Unplug the machine and close the tap.
Contact for service.
Contact for service.