Panasonic DMP-BD84GN Operating Instructions Manual page 29

On-Screen Messages
Choose whether to show status messages
automatically.
HDMI CEC
Set to use "HDMI CEC" function when
connected to a device that supports "HDMI
CEC".
≥ Select "Off" when you do not want to use
"HDMI CEC".
∫ Start-up Banner
Select whether to display the banner after turning
on this unit. ( 16)
∫ Quick Start
Speed of start-up from standby mode is
increased.
[For_the_United_Kingdom_and_Ireland]
≥ When set to "On", the internal control unit will be
powered and in Network standby mode. The
idle power consumption will increase so
compared to when set to "Off".
(Power consumption
[For_Australia_and_New_Zealand]
[For_the_South_East_Asia_and_HongKong]
≥ When set to "On", the internal control unit will be
powered and the idle power consumption will
increase so compared to when set to "Off".
(Power consumption
∫ Remote Control
Change the remote control code if other
Panasonic products react to this remote control.
∫ Firmware Update (
Press [OK] to show the following settings:
Automatic Update Check
When this equipment remains connected to the
Internet, it will check for the latest firmware
version when it is turned on and you can update
it if necessary.
Update Now
You can update the firmware manually if a
firmware update is available.
34)
34)
15)
Settings
∫ System Information
Press [OK] to show the following settings:
Software Licence
Information about the software used by this unit
is displayed.
Firmware Version Information
Display firmware version of this unit and
wireless LAN module.
∫ Default Settings
This returns all values in the Setup menu and the
Option menu to the default settings, except for
some settings of network, ratings, remote control
code, on-screen language*, etc.
* [Except_Australia,_New_Zealand]
- 29 -
[BDT280]